Dana-Spicer
On a 2005 Peterbilt 379, the expansion valve is typically located in the HVAC system, specifically within the air conditioning unit or evaporator assembly. It is usually found near the evaporator core, which is situated behind the dashboard or under the hood, depending on the configuration of the truck's air conditioning system. For precise location and access, it's advisable to consult the vehicle's service manual or schematics.
3:05
yes but you would have to change your rims and the gears that connect to your axle
The setting would be around 7 route in order to have a correct setting of axle.
To replace the axle shaft on your Ford Crown Victoria 2005, you will need a specialized tool called a slide hammer. Once you remove the axle make sure the area is thoroughly cleaned, You can find replacement axles at most reputable auto parts dealers, and most are available online.
all depends on the tire size.
173ft-LBS.
On my 05 Prius the problem was the axle height sensor located near the left rear wheel.
yes the two should be the same the front axle has not changed
To remove the axle shaft from a 2005 Ford F-350, first, ensure the vehicle is securely lifted and supported. Remove the wheel and brake components, then disconnect the differential cover and drain the fluid. Next, unbolt the axle retaining bolts, slide the axle shaft out of the housing, and carefully pull it free from the differential. Be sure to inspect the seals and bearings for damage before reassembly.
Don't waste your time taking out the half shaft. Take the few bolts that are holding the rest of the axle and remove the half shaft with the other part of the axle all together. Its a hundred times easier. That's what we did in my 05 RSX type S. when we pulled the trans. out of the car.
The EVAP canister assembly is located underneath the vehicle behind the rear axle below the spare tire well.