There should be a button on the top of the seat near where the shoulder belt comes down the seat. If that doesn't release the seats check in the trunk that the lock hasn't been switched to the locked position.
my 93 Honda has a lock on it to fold down rear seats look ,look between rear speaks towards the front, ignition key should unlock seats
There's a tab on each end of the backseat on the top (they are visible) pull upwards on both of them and pull the back seat towards you. There you go.
Yes. I have the 2-door coupe (non hatchback) and the seats fold fairly flat. There is a lock mechanism on the rear sill (by the base of the rear window) that you have to unlock with your key, or there is a release for each seat in the trunk.
The Chevy Tahoe seat will still fold up but to fold the seat backs down into the flat position you will need to follow one or both of the guide wires to the locks which are held up by springs. Once you locate them (main one is toward the center of the vehicle) you can pull them forward with just your finger if you are strong or use a screw driver or tool from the tool kit if it is located under the seat. You must pull the seat back forward when you are holding the spring lock forward otherwise it will spring back into the locked position. Make sure it locks properly if you put the seat back up into its normal passenger position.
To fold down the rear seats in a 2006 Chevy Malibu when the trunk is locked, you can access the release mechanism through the rear passenger doors. Pull the seat release levers located on the top of the seatbacks to fold them down. If the trunk lock is preventing access to the trunk area, ensure that the doors are unlocked, as the seats may be designed to fold down only when the doors are open. If the seats still won't fold, check for any obstructions or malfunctions in the release mechanism.
On the outside top edge of each back seat there is a knob which needs to be pulled upwards to release the lock. Similarly once in the 'down' position you need to pull the knob to release the lock. On the outside top edge of each back seat there is a knob which needs to be pulled upwards to release the lock. Similarly once in the 'down' position you need to pull the knob to release the lock.
If you fold down the back seats and look through the opening with a flashlight you can see a T-handle attached to the back of the trunk to the right of the center. That has to be pulled in order to open a stuck trunk. There is no key hole on a 2005 Altima.
Looking at the seat back in its reclined position - on the ouboard edge of the seatback (closest to the door) is a rectangular plastic tab embedded into the top of the seatback. Pick up on this tab and it will release the lock that holds the back down. This is the same tab that also releases the seatback to fall into the 'down' position.
Sometimes you have to shimmy the steering wheel back and forth while trying to put the ignition to lock position. Many vehicles do this.
you pull the lever on the right side up and fold it forward and it'll lock. aight? holla
There should be a release lever on the rear left close to the bottom of the seat. Flip it out to release & fold the seat back onto the bottom then lift them both & fold foreward. But there is no lock so unless you have something that will hold it there, it will not stay.