0
Remove 2 bolts in front on the bottom of the engine cover. Remove 2 Phillips bolts in the ash tray area. and lastly there are two latches toward the back of the cover....one on each side. You then pull the bottom of the engine cover toward the rear and tilt the top out slowly. It's easy.
What else can I help you with?
How do you remove the brake light cover on a 1991 tracker?
how do you remove the brake light cover on a 1991 gmc tracker? Do you go from the outside or inside?
How do you replace the water pump on a 1991 Toyota Camry 2000?
on the 3S-FE engine, you will have to remove the engine from the car, then pull the cover off where the timing belt is. The water pump is inside there. It's a JOB.
Will 1993 cam cover fit 1991 evo engine?
If it is a two hole riveted cover
How do you take out the motor in a 1991 Toyota MR2?
To remove the motor from a 1991 Toyota MR2, first disconnect the battery and drain the fluids. Next, remove the engine cover and disconnect all electrical connections, fuel lines, and any other components connected to the engine, including the exhaust system. Then, support the engine with a hoist or engine stand, and unbolt it from the transmission and engine mounts. Finally, lift the engine out carefully, ensuring all connections are detached.
Were is the neutral switch on a 1991 Honda TRX300 fourtrax fwd?
This is also known as the gear position switch. It is inside of the rear crankcase cover. You must remove this cover to service it or renew it. The neutral switche is combined with the reverse switch and I am pretty sure you have to remove the engine out of the frame to do this job.
Where is the fuel pump located on the 1991 Nissan 240?
remove rear compartment floor trim remove greenish colored cover screws remove cover remove screws from pump assy and lift out.
Where is the brain on a 1991 cutlass supreme quad4 engine?
The brain or ecm is located on passenger side, underneath glove box. Remove a few 6mm screws and there it is behind plastic cover.
How do you replace the heater core in a 1991 Ford Explorer?
Answer replacing the heater core on a 1991 explorer is a simple job and takes around 30 minutes. disconnect the hoses from core in engine bay. remove access cover located below the dash on passenger side. remove core, replace core.
Where is locate the starter on Mitsubishi eclipse 1991?
On a 1991 Mitsubishi Eclipse, the starter is located on the lower side of the engine, near the transmission. Specifically, it can be found on the right side of the engine block, close to the rear. To access it, you may need to lift the vehicle and remove any obstacles, such as the engine cover or heat shield, for better visibility and access.
How do you remove the steering wheel horn cover on a 1991 Honda hatchback dx?
The steering wheel cover on a 1991 Honda Civic DX is held on by several mounting screws. Remove all the hardware and the steering covers will just pop off.
How do you change the glass headlight cover on a 1991 300E?
You have to remove the entire headlight assembly. Glass cover clips on with plastic clips. Remove and install CAREFULLY as glass breaks easily.
How do you change a timing chain on 1991 Chevy Corsica?
To change the timing chain on a 1991 Chevy Corsica, first disconnect the battery and remove the necessary components, such as the engine cover, front timing chain cover, and crankshaft pulley. Align the timing marks on the camshaft and crankshaft to ensure proper timing. Remove the old timing chain and replace it with the new one, ensuring it is properly tensioned. Finally, reassemble the engine components, double-checking all connections before starting the vehicle.
