There's one procedure for changing starter motors that works on everything from a Volkswagen Bug to a semi tractor.
1. Unhook the battery.
2. Find the starter. There will be two wires running to it. The fat one (it goes to the battery) is bolted on, the thin one (it goes to the ignition switch) has a push-on connector. Disconnect both wires.
3. The starter is held to the engine with two bolts. Remove the nuts and then the starter. Be careful because these are heavy--and the bigger the engine is, the heavier the starter.
4. Put the new starter in place and bolt it in. Tighten the bolts very tight.
5. Reconnect the two wires, then hook the battery back up and you're done.
Quick note: Before you unhook anything, get a little piece of wire, strip both ends and short the two wires together WITH THE VEHICLE IN NEUTRAL AND THE WHEELS CHOCKED!!!! If the starter cranks the engine the problem is somewhere in the ignition-switch circuit, not the starter.
To remove the starter motor from a 2001 Opel Corsa diesel, first, disconnect the negative battery terminal to ensure safety. Then, locate the starter motor, which is typically mounted near the transmission. Remove the electrical connections and the mounting bolts securing the starter in place. Finally, gently pull the starter motor out and replace it with the new unit, reversing the steps.
Opel Combo was created in 1994.
In an Opel Combo van, the starter motor is typically located on the driver's side of the engine bay, mounted to the engine block near the transmission. It's usually positioned towards the lower part of the engine, making it accessible for maintenance. To locate it easily, look for a cylindrical component connected to the battery and ignition system. Always ensure the vehicle is off and the battery is disconnected before attempting any work in that area.
Opel Kadett Combo was created in 1986.
under the bonnet.
To change the starter motor on an Opel Corsa, first disconnect the negative battery terminal to ensure safety. Then, remove any components obstructing access to the starter, typically located near the engine's transmission. Disconnect the wiring harness and bolts securing the starter motor, then carefully remove it. Finally, install the new starter by reversing the steps, ensuring all connections are secure before reconnecting the battery.
To replace the clutch on an Opel Corsa, first, safely lift the vehicle and remove the transmission. Disconnect the battery, then remove the drive shafts, starter motor, and any necessary components obstructing access to the clutch assembly. Replace the old clutch plate, pressure plate, and release bearing with new parts, ensuring everything is correctly aligned. Reassemble the transmission and other components, and then lower the vehicle before reconnecting the battery and testing the new clutch.
4.5-5.0 Quarts.
I Have a Cosa Combo and need the correct Tow Capacity of this Van , because i have To buy a new Hose Box , and the Dealer need to know , how much the Combo can Tow
The fuel efficiency of the Opel Combo varies depending on the specific model and engine type. Generally, it can achieve around 30 to 50 miles per gallon (mpg) in mixed driving conditions. For exact figures, it's best to refer to the manufacturer's specifications or check the model year and engine variations.
The Opel Combo's inhibitor switch is typically located on the transmission assembly, specifically near the gear selector. It is responsible for preventing the engine from starting unless the transmission is in the park or neutral position. For exact location details, it's best to consult the vehicle's service manual or a professional mechanic, as the position may vary slightly depending on the model year.
The 2007 Opel Combo typically features a timing belt rather than a timing chain. Timing belts are common in many vehicles of that era, and they generally require periodic replacement to prevent engine damage. It's important to check the owner's manual or consult with a mechanic for specific maintenance recommendations for your vehicle.