1. Remove wiper arms and blades.
2. Remove cowling between hood and windshield. Make sure that you find and remove all the screws before you try to lift the cowling off. You may need to raise and lower the hood a little to get the cowling out.
3. Loosen the four bolts that connect the two wiper transmission arms to the wiper motor, then remove each arm. Remember to mark the position of each arm, this will affect the position of the wipers on the windshield.
4. Unplug the wiper motor electrical connector.
5. Loosen and remove the mounting bolts of the motor, then you should be able to remove the motor.
6. Install new motor in original position, use the same bolts and tighten. Then reconnect the electrical connector.
7. Connect the transmission arms one at a time to the motor, remember to put them in the marked positions. Don't tighten the bolts to tight.
8. Before re-installing the cowling, temperately install the wipers to make sure you have the correct alignment.
9. Once the transmission arms are installed and aligned it is time to put the cowling back on. Use the same method with the hood to get it back in position.
10. It never hurts to replace the wiper blades with this repair.
GOOD LUCK
how do you replace the wiper motor pulse board on a 1999 Chevy Silverado 2500
replace rear window wiper motor on 2001 Chevy venture
Replacing a wiper motor on a 2004 Chevy Impala can be difficult. It is best to take it to an auto repair mechanic or an authorized Chevrolet dealership.
Very Carefully
To replace the wiper motor on a Chevy 3500, first, disconnect the vehicle's battery to ensure safety. Remove the wiper arms by unscrewing the nuts at their bases and gently pulling them off. Next, take out the screws securing the wiper motor cover and disconnect the electrical connector from the motor. Finally, unbolt the motor from its mounting and replace it with the new unit, reassemble in reverse order, and test the wipers before securing everything back in place.
Remove the wiring harness from the back of your 1995 Chevy Lumina front wiper motor. Remove the traveling arm linkage from the wiper motor. Remove the wiper motor retaining bolts. Reverse the process to install the new front wiper motor.
Replace the wiper motor with a NEW one (do not use a rebuilt!)
Inside the wiper motor.
How do you remove and replace wiper switch on 2002 Chevy Cavalier
Bad switch or bad motor is most likely cause. Motors should have been recalled by Chevy. If you replace motor, replace with new one- do noy replace with a rebuilt motor.
Remove the wiring harness from the back of your 1994 Chevy Cheyenne wiper motor. Remove the traveling arm linkage. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
How to replace wiper motor on a 1998 montero sport mitsubishi