0
What else can I help you with?
I am looking for a 532 Ford baler for parts or one that is running...?
I have a 532 baler working now in N.Ky.
I am looking for a 532 Ford baler for parts or one that is running..?
I have a 532 baler working now in N.Ky.
How old is a 542 Ford Baler?
They made the 532 and 542 from 1/69-12/81.
How do you time a ford 532 bailer?
To time a Ford 532 baler, first ensure the machine is properly set up and connected to the tractor. Locate the timing marks on the drive pulleys or the flywheel, and align them according to the manufacturer's specifications. Next, check the knotters to ensure they are properly synchronized with the plunger stroke. Finally, make any necessary adjustments and test the baler to confirm it is operating smoothly and efficiently.
What does a john deere baler weigh?
how do time a 24 t john deere baler
Where can you buy baler needles for a Ford 542 hay baler?
Try ebay and a general google search, I found several for sale and parting out listings in the first 20 results.
What is the theme of baler?
The primary theme of the movie Baler is Love. It is about the love of Feliza for the soldier man during the time of war.
How do you time Massey Ferguson Model 12 hay baler knotters?
How do adjust the knotters on #12 Massey Fergurson hay baler
How do you thread a ford 532 wire hay baler?
Run the twine out of the twine box and through the guide next to the needle. Then run the twine through the needles and tie it off somewhere. When the knotter trips, it will inject the twine into the knotters and it will be threaded. If your baler has been sitting for awhile, it might take a few cycles for it to start knotting properly due to rust. for starters if it's a wire baler it doesn't have twine or knotters; it has wire and twisters. but it's true you thread it through the guide holes in balewire box, down through the sheaves, up over sheaves just before the needles and across the top of the needles then tie it off to the brace just like a twine baler. be careful, make sure it's centered over the top of the needles. after it makes a cycle you should be able to see if it picked up the wire and has held it in twisting grippers. it is held in these until the wire goes around the bale, then it should twisted and cut. make sure sheaves that wire goes through are lubricated with wd40 or something similar. i bought my 532 about five years ago and it does a good job. i think you can still get a manual for this baler from your ford ag dealer.
Reflection of baler film?
reflection about baler
Will a Massey Ferguson 12 baler take plastic string?
I have a model 12 MF baler, and I use the plastic twine all the time with no problems. Don in Oregon
What is 18 percent of 532?
18% of 532 = 18% * 532 = 0.18 * 532 = 95.76
