answersLogoWhite

0

The cost of a Water Driver Series 3500 pressure washer typically ranges from $300 to $700, depending on the retailer and any additional features or accessories included. Prices may vary based on location and availability. It's best to check with specific retailers or online platforms for the most accurate pricing.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

What do you use in your Pressure washer?

Water.


What type of pressure washer hose fitting should I use for optimal performance and compatibility with my pressure washer?

For optimal performance and compatibility with your pressure washer, use a hose fitting that matches the size and type recommended by the manufacturer of your pressure washer. This will ensure a secure connection and efficient water flow during operation.


Why does your Kenmore 70 Series washer not stop filling with water?

There is a clear hose attached to the water level control of the washer. The other end of the hose is attached underneath the washer. The hose isn't attached with any hose clamps so if the washer rocks from a uneven load it could come disconnected and on the next load the water fills up and never stops. Just disconnect the water and electric and the drain and turn the washer on its side look for the hose and reattach it to the hookup underneath-- I just fixed mine, I thought I was going to be buying a new washer but this one still works great now! Hope this helps- Jesse


What is the best way to connect a pressure washer connector to a garden hose?

The best way to connect a pressure washer connector to a garden hose is to first ensure both the pressure washer and garden hose are turned off. Then, attach the pressure washer connector to the garden hose by screwing it on securely. Finally, turn on the water supply and check for any leaks before using the pressure washer.


Is the amount of pressure in a gas powered pressure washer dependent on home water pressure?

No, it most cases it it the GPM demand


What is a pressure washer?

Basically, a pressure washer uses pressurization to deliver a concentrated spray of water or liquid. The force of this stream enables you to deep clean surfaces. But be careful what you use a pressure cleaner on - the force of the water can harm some surfaces. A pressure washer is a machine that pressurizes enough pressure to blast out a forceful spray of water that can deep clean an area and rid it of grime and mold. Pressure washers are used by painters to peel away paint from a house.


What is the GPM (gallons per minute) of water flow for a pressure washer?

The GPM (gallons per minute) of water flow for a pressure washer typically ranges from 1.5 to 4 GPM, depending on the model and size of the machine.


Why after the hot water in the kitchen heats up the pressure goes out and trickles the hot water?

As the water heats up the washer in the tap, it expands. This causes the washer to partially block the open valve.


How does a pressure washer pump work to generate high-pressure water for cleaning tasks?

A pressure washer pump works by using a motor or engine to drive a piston or impeller, which pressurizes water from a hose. The pressurized water is then forced through a nozzle at high speed, creating a powerful stream of water that can effectively clean surfaces.


Water pressure washer has not pressure?

If it has no pressure your problem should be on the pump. The three things I'd recommend you to check are: Packings, Unloader and Valve Kit.


What is the GPM (gallons per minute) rating on a pressure washer?

The GPM rating on a pressure washer refers to the gallons of water it can spray per minute. This rating indicates the machine's water flow capacity, which is important for determining its cleaning power and efficiency.


Why does your Kenmore 60 Series washer not stop filling with water?

Take the cover off where the controls are at and there is a pressure switch with a hose connected to it. It should be round, about 2- 2 1/2 inches in diameter and maybe an inch thick. If your washer has a load size adjustment, it is what the knob attaches to.