Different uses different widths. If you are installing a service walk around your garage, or similar area 24" wide is adequate. A front walk or an area where people walking in opposite directions will occassionaly meet should be 36" wide. A comfortable sidewalk where 2 people can walk side by side should be 60" wide.
ADA requires 36" minimum with turnouts for passing every 200', otherwise make it 60" wide without the need for turnouts.
While you are here lets talk about sidewalk thickness. Sidewalks should be 4" thick, but quite honestly most contractors use a 2x4 to form the sidewalk so they wind up being 3 1/2" thick, which works fine. If you will be driving a car or light truck over a section, increase it's thickness to 6"
Note these widths will work with all residential applications. Some commercial applications may require wider and thicker sidewalks.
Yes, it should be. If the sidewalk is not higher than the lawn water will collect on top of the sidewalk when it rains. If the temperature drops below freezing the sidewalk could crack.
3' wide, about 31'----4' wide, about 24'
The answer will depend on what material the sidewalk is made from and the maximum range in temperature.
When possible, pedestrians should walk: On the right side of the road to avoid oncoming cars.
Bicyclists should dismount and walk their bikes when in a crosswalk or on the sidewalk to ensure pedestrian safety and follow traffic laws.
$1,850
152/(6*6) = 4.22... (recurring) feet.
Enough to lay a four foot wide sidewalk around the earth.
Private walks typically 3 ft wide. Public walks, 4 ft wide but vary by municipality and handicap accessibility.
A typical residential sidewalk is usually about 4 to 5 feet wide. This width allows for comfortable pedestrian traffic, accommodating two people walking side by side. In some areas, sidewalks may be narrower at around 3 feet, especially in more urban or space-constrained settings. Local regulations and design standards can also influence sidewalk width.
A sidewalk is a thin ribbon of concrete, not meters. Even with this modification, the question doesn't mention whether it seeks the length, width, or thickness of the sidewalk, and each is a different number.
To run electrical or drip line under an existing sidewalk, you can use a pipe or conduit that is large enough to accommodate the wires or tubing. First, dig a trench on both sides of the sidewalk, taking care to avoid damaging the sidewalk. Then, use a tool such as a tunneling kit or water jet to bore a hole or create a tunnel underneath the sidewalk to run the lines. Once the lines are in place, backfill the trenches and repair any damage to the sidewalk.