0
What else can I help you with?
What is the purpose of warming up and preparations using the main engine?
The purpose of it is that it helps you know that the main engine is working and is in good condition before using it.
What is part load in internal combustion engine?
"Part Load" is short for partial load. "Load" is when the engine is doing work. Whatever work the engine is doing places a "load" on the engine which resists the engine's turning motion and slows the engine down so it requires more throttle to maintain speed. "Partial load" is when the engine is doing work that would stall the engine at idle, but does not require full throttle, just partial throttle. A good example would be a car traveling at highway speed or up a slight grade.
What are mechanisms employed in a spark ignition engine to vary the ignition timing depending on the speed and the load of the engine?
I don't know I'm also still searching the answer for this question.
What are the three main categories of engine. write your answer below?
i don't know tell me pls about that !
How does load affect fuel consumption in a truck engine?
The higher the load the more fuel will be used to move that load. The engine must work harder the more weight it must pull. The harder the engine works the more fuel it uses.
What is load lemiting governor?
A load limiting governor is a device that regulates and measures the amount of fuel that enters the engine. The load limiting governor will ensure that there is not more than enough that will enter the engine.
What power plant has high load factor?
Diesel Engine has high load factor
What would make the engine cut out under a load on a 1990 Oldsmobile 88 Royale?
From my unfortunate experience and the amount of information I gathered on the subject, two sources of faults can make your engine cut out under load (I assume it is not a diesel engine): ignition or fueling. Ignition: if the spark is "weak", it will be smothered when the engine is under load, giving poor or no combustion. Main reason for this would be bad High Tension leads or ignition coil primarily, or too big a gap in spark plugs. Fueling: A clogged filter or an ageing/dying fuel pump would allow the engine to idle or rev freely under no load, but as soon as you are asking for some power from the engine it would just die. In both cases, the engine may seem to be running perfectly OK when not under load. Hope this helps.
Does a disconnected ground to the engine block take away power?
Yes. The main ground is to the engine block. If that main ground is disconnected, the circuit will try to find ground through smaller connections which usually ends up with the smaller grounds not big enough to carry the load of the starter and they melt.
Diesel engine loss of rpm under load?
yes because load affect the efficiency of engine , it can be improved by increasing the supply of oil in governer.
What happens to the engine RPM when load is increased?
When the load on the engine is increased, the engine RPM typically decreases because the engine has to work harder to overcome the additional resistance. This is due to the increased demand for power output to maintain the same speed or acceleration.
What is the function of main engine?
Main propulsion is the function of the marine main engine.
