0
As stated in a factory manual. (1) Didconnect & isolate the negative cables of BOTH batteries. (2) Raise & support the vehicle. (3) Pull back the protective rubber boot from the starter solenoid power cable (on top of starter) far enough to access and remove the nut that secures the cable and remove the cable. (4) Remove the nut that secures smaller solenoid wire and remove the wire. (5) Loosen the three starter bolts and take out the two hardest to get to. (6) Support the starter with one hand and remove the remaining bolt with the other hand. Then lower the starter down. (7) Reverse this list to install. Hope this helps.
What else can I help you with?
Where is the crankshaft sensor located on a 1999 Dodge Cummins?
It is behind the starter in the block.
1999 cummins dodge ram- starter bolt head size?
10mm 12 point
Where is the starter motor on a 1999 dodge ram 3500 with cummins diesel?
Lower rear of driver side of engine.
Why doesn't my 1999 Dodge Ram 2500 with a Cummins diesel not crank Have new alternator batteries are fine and I get good voltage to the starter?
If yo have power to both wires at the starter when trying to crank, the starter is failed.
Does a 1999 dodge 3500 with a 5.9 cummins have glow plugs?
No, the Cummins uses an intake heater grid.
Where is the starter solenoid located on 1999 Dodge Dakota?
The starter solenoid on a Dodge Dakota is built on the starter.
How much oil does a 1999 dodge Cummins take?
12 quarts
Is there a starter solenoid on a Dodge Intrepid 1999?
On top of the starter
Can you use a 1999 cummins motor in a 1997 dodge diesel truck?
Yes
Where is the starter on a 1999 Dodge Durango 5.8 liter?
A 1999 Dodge Durango did not have a 5.8L engine option. The starter on a 5.2L or 5.9L is
Where are a list of Error codes for 1999 Dodge Ram 3500 cummins diesel?
ask your local dodge dealer
How much oil does a 1999 Dodge 5.9 Cummins take?
12 quarts 15w40
