It stands for digital volt-ohm meter
One million
set your DVOM to A/C then back probe both wires- Shop Leader Oloughlin (Wyotech student)
It is a VRS sensor. You set the DVOM to AC and back probe both wires. (Wyo Tech student)
A VRS sensor and you can measure it with a DVOM on A/C Votlage by probing both wires and cranking the car.
.09
The "bus" is the communication system between computers on the vehicle. "No Bus" means that the system has stopped functioning. A scan tool, DVOM, and wiring diagrams are required to diagnoseThe "bus" is the communication system between computers on the vehicle. "No Bus" means that the system has stopped functioning. A scan tool, DVOM, and wiring diagrams are required to diagnose
The "bus" is the communication system between computers on the vehicle. "No Bus" means that the system has stopped functioning. A scan tool, DVOM, and wiring diagrams are required to diagnose.The "bus" is the communication system between computers on the vehicle. "No Bus" means that the system has stopped functioning. A scan tool, DVOM, and wiring diagrams are required to diagnose.
Go
The Diode Check setting on a DVOM is a special ohms setting that presents enough voltage to the tested device to conduct, if it were a diode. Old style VOM's did not have this problem, because they usually used a battery greater than 0.7 volts to run the ohm's scale. Modern DVOM's, however, can use very small voltages to measure ohms, and that would not cause a diode to conduct. The Diode Check setting fixes this limitation.
12 volt
10 mega ohms.
10 mega ohms.