It is to distribute the signals from the electronic control module to operate the coils.
There are many reasons that is why it is a multi purpose vehicle.
The Apollo Lunar Module was designed to transport astronauts from lunar orbit to the moon's surface and back. It served as the "landing craft" for the Apollo missions, providing a safe way for astronauts to land on the moon, explore its surface, and then return to the Command Module in lunar orbit.
The eagle was the lunar module that carried astronauts Neil Armstrong and Edwin "Buzz" Aldrin to the surface of the moon during the Apollo 11 mission in July 1969. Its purpose was to safely land on the moon, allow the astronauts to conduct their mission, and then return them to the command module orbiting above.
The fuse protects the circuit that powers the transmission control module.
It sends the proper signal to the ecu to allow certain curcuits to close to allow power to the acc, on and run positions with the key.
They were just not built to do it... too heavy, no legs, etc. Command Modules do not land on the moon. The command module is the main capsule for the Apollo program. The lunar module of Apollo 11 however did land on the moon on the 21st of July 1969.
Store encryption keys that can be used to encrypt and decrypt secondary storage areas like the hard disk
The purpose of a proximity card reader is the contactless exchange of data between the reader and the card. Traditional card readers need the cards to be inserted in a module to be read, which is not necessary in case of a proximity reader.
Me Module
When a module is called, the computer jumps to that module and executes the statement in the module's body. Then, when the end of the module is reached, the computer jumps back to the part of the program that called the module, and the program resumes execution at that point.End
I know that in the 1991 Chevy Camaro Z28 the Pass-Key Decoder Module is located right behind the dash on the right hand side. (Passenger side) If you remove the top dash piece. You will see the speaker. just to the left of the speaker you will see/should see a metal bracket. The module is attach it. Just remove the 7mm screw and carefully pull the module up. BE CAUTION NOT TO HIT THE WINDOW. Note: You will find that the module will be hitting a small plastic piece. You can fight with the module or you can just cut out the small plastic. It's up to you. It does not serve any real purpose. Good luck!