The main purpose of the ignition module is to control the timing and operation of the ignition system in an internal combustion engine. It regulates the spark timing and firing of the spark plugs, ensuring efficient combustion for optimal engine performance. Additionally, the ignition module manages signals from various engine sensors to adjust the ignition timing based on engine conditions. This helps improve fuel efficiency, reduce emissions, and enhance overall engine reliability.
It is to distribute the signals from the electronic control module to operate the coils.
The "brain" of the ignition system, the Ignition control module controls the ignition timing and strength, as directed by the main computer. It can be located in a variety of places, but it can normally be found underneath the hood.
The "brain" of the ignition system, the Ignition control module controls the ignition timing and strength, as directed by the main computer. It can be located in a variety of places, but it can normally be found underneath the hood.
where is the ignition module located on a 1988 Mazda b2200
What engine? Ford contour 2.0L DOHC eng. distributorless ignition are controlled by the main PCM There is an ignition module on the 99 contour 2.0 with automatic transmission. It is shown in the schematics for this model.
The engine computer is the ignition module.
The engine computer is the ignition module.
Where is the ignition module 97 explorer
Start the car
It sends the proper signal to the ecu to allow certain curcuits to close to allow power to the acc, on and run positions with the key.
Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.