Reverse is top far left. Lo is directly underneath. first is top middle, second is bottom middle, third is top right, fourth is bottom right. in high range, fifth is where first is, sixth is where second is, seventh is where third is, eight is Where fourth is.
No way to answer this without knowing what transmission you have in there.
truck start shift is hard to move in gear
97 Chevy Z71 truck will not shift into third gear.
Between 1st and 2nd gear.
There is no synchronizer gear in these, so you do the synchronization. You're not going to learn about it by reading about it... perhaps a truck driving school would be in order.
First gear down, the next four are pulled up.
they told me on mine it was a w stands for the kind of curve my gear shift has
The 2004 Harley-Davidson Fat Boy utilizes a standard gear shift pattern typical for most motorcycles, which is a 5-speed transmission. The pattern is one-down for first gear and four-up for the remaining gears, meaning you shift down to engage first gear and then shift up sequentially through the gears. To shift, the rider uses the left foot to operate the gear shift lever. Always remember to use the clutch when shifting to ensure smooth transitions between gears.
There were three trans mission options. four speed five speed and 10 speed power shift with 2 reverse.
All American cars with a 3 speed manual have the same shift pattern. The pattern is in an H. Reverse is to the left and up. First is the the left and down. Second is to the right and up and 3rd (top gear) is to the right and down.
You can fix a broken linkage in a 1999 Navigator truck by simply adjusting its Gear Shift.
I'm not real sure what your question is but I'll try to answer. In all cases speed within a gear selection depends on your trucks rear differential gear ratio. If you mean what is the lowest speed you can shift to third gear you should be able to drive on flat surfaces as low as 20 mph. If your truck seems to run well you are OK. If your truck jerks or seems to be laboring, you probably have a very high gear in the rear end and may need to wait to about 25 mph. If you are talking about the maximum speed you can go in third gear you will know when you reach it because you will have also reached maximum effective RPM on your engine and the truck will simply not go any faster in that gear.