0
What else can I help you with?
What transmission oil is good for a big truck?
Eaton Fuller recommends 50W synthetic. Not sure about other transmission manufacturers.
How 1976 Chevy truck shift indicator how to repair needle stays in park when you shift gears its a auto the indicator is on the steering column?
there is a small string ,and spring connecting the gear selector needle, and the shift collar on the steering column. that is what has to be replaced. you should be able to remove parts of the dash to get to it. It usually isn't a big job.
What is a good gear ratio to run with turbo 350 trans?
There is no real way of answering this without knowing the dimensions of your tires and what the application is. Big difference in how you'd gear a station wagon vs. how you'd gear a mud bogging truck.
How do you tell rear end ratio on 1978 Chevy truck?
To know for sure, You need to remove the big metal plate on the rear end housing and count the # of teeth on the BIG round gear / Ring gear. Then count the teeth on the small round gear / pinion gear that sets deep in the housing and runs on the big gear. Then divide the small # into the high # and that will be you gear ratio.
1999 Mercury Sable will not shift to drive gear?
Linkage is broken or loose - or trans pump shaft is broken ( big job)
Why is the Shift lever hard to operate?
because youcould easily bump it in to a wrong gear while your driving and could lead to big diasters!!
How do you shift 8 speed transmission?
If it is an eight speed in a truck, chances are it is a big rig of some sort. Push the clutch in and put the shifter in first gear. Slowly let off the clutch until the truck starts to move. Speed up until it feels like you need to shift again. You can slip the shifter out of first and into second without using the clutch if you are quick and get the feel of the engine RPMs. If you want to use the clutch you will need to double clutch. Push the clutch in to shift from first to neutral. Now let the clutch out so the engine and transmission gears start turning at the same speed. Now, quickly clutch again and shift into the next gear. let off the clutch and accelerate again. If you have a four speed with a two speed rear end there will be a switch on the shifter. Shift through the first four gears normally, then flip the switch an go back to 1st, which will become 5th gear with the axle in high range. To down shift you should double clutch too. First, clutch to shift into neutral. Let off the clutch and rev up the engine so the RPMs are correct for the vehicle speed and the next gear you want to shift into. Now clutch again and downshift. When you let off the clutch the engine, which can only turn so fast, will pull the truck speed down. You can give the engine some throttle and slowly back off so the engine braking isn't so rough or sudden. Good Luck!
Will 1996 5.0L Chevrolet push 36 inch tires good?
That depends on the gear ratio in the rear ends, not the engine. To make the truck have POWER with those big tires you need at least a 4.10 gear in the rear ends.
When was Big Ol' Truck created?
Big Ol' Truck was created in 1994.
When a big gear turns a small one the output provides more?
A big gear turning a small gear means the small gear will spin faster, but weaker.
Toll for big truck across the gwb?
it is 8.00 $ per axle for a big truck
If you are on gear one are you on a big gear or a small gear?
1st gear is the gear where you can pedal with the least resistance. For a bicycle with external gears the chain should be on a big sprocket at the back and a small chainwheel at the front.
