Making a channel for passing data into or outside the PC .For example if I need to store a file in a USB flash drive from my PC .Then My PC would send the file contents in digital form to the USB flash drive through it data bus connection.
The Intel 8088 is generally considered to be a 16-bit processor (most registers were 16 bit registers), and therefore had a 16-bit word length, although its external data bus was only 8 bits wide.
Serial and USB ports are most often used to connect an external modem to a PC.
The PC power supply box's function is to supply the computer with power. Without the PC power supply box, the computer would not be able to turn on and off.
Upload is transfer of data(information),where data is sent from local system(e.g. home PC) to some remote system(server,other PC etc).
what is the fuction of a client Pc The client is a function in a Client/Server on a network. you can be a Client in school or work or at home..
Memory Controller Chip
No, within a bus topology, the client PC's are indepentent of each other. So if PC 1 fails, PC 2 will still be connected to the server. But, PC 2 won't be able to get data/information from PC 1.
Yes
A Hard drive in a PC is used to store Operating System and software data so the PC will function.
The 8088 was the microprocessor used in the original IBM PC, released in 1981. It operated at clock speeds of 4.77 MHz, which was relatively slow by modern standards. The 8088 featured a 16-bit data bus and an 8-bit external data bus, allowing it to handle a variety of tasks suitable for early personal computing. Its architecture laid the groundwork for future generations of x86 processors.
The Intel 8088 microprocessor was a variant of the Intel 8086 and was introduced on July 1, 1979. It had an 8-bit external data bus instead of the 16-bit bus of the 8086. The 16-bit registers and the one megabyte address range were unchanged, however. The original IBM PC was based on the 8088.
The PC AT bus, also known as the ISA (Industry Standard Architecture) bus, typically operates with a data bus width of 16 bits. It was originally designed for the IBM PC/AT and supports a maximum of 20 address lines, allowing access to 1 MB of memory. The bus facilitates communication between the CPU and peripheral devices, such as expansion cards and other hardware components. The ISA bus was widely used in personal computers during the late 1980s and early 1990s.
Because IBM wanted to build a computer with an 8-bit data bus. The 8086 and 8088 are the same processor, with the 8086 running on a 16-bit data bus, and the 8088 running on an 8-bit data bus. This allowed IBM to make the most use of older designs that supported 8-bit data buses, such as the 8080, the 8085, and the Z80.
Actually there are several options and strategies in order to prevent data loss on a PC. One could for example store the personal / important data on a RAID 1 storage medium which actually mirrors the data. Another option would be to do regular backup stored on an external device of the most important data.
Cables carry the electrical signals necessary to transfer data from one system to another.
NO. A computer port is a hardware or virtual device (software) that allows data to pass from one area to another of the PC's hardware and/or software environment. The Periphial device is usually a hardware device the needs to interface with the appropriate port in order to send, receive or interact with the PC and other devices attached to the PC. An example would be somthime like a USB (universal serial bus) external hardive attached to a USB port in order to read and write data.
The Intel 8088 is generally considered to be a 16-bit processor (most registers were 16 bit registers), and therefore had a 16-bit word length, although its external data bus was only 8 bits wide.