0
What else can I help you with?
Ios in networking fullform?
what is fullform of osi, ios,and iso .?
What is the fullform of friend?
h
What is the fullform of hotel?
HOTELS
How do you test a light emitting diode?
You can test it by puting it in forward bias with a resistor. Use a dc voltage source of 5 volts and put it in series with 250 Ohms resistor. Or use 9volts with a 450 Ohms resistor. Basically you need 20mA of forward current usually. Smaller current will reduce brightness.
What is fullform of DDE?
Dde full form
Difference between gunn diode and pin diode?
gunn diode is transfered electron device & PIN diode is semiconductor device
Is pin diode and led diode are same?
no
How do you use diode in a sentence?
Example sentence - The little red diode can be used as a pin on a tie.
Has Pin diode depletion layer?
S it has Clinton
Why pin diode is used at high frequenc?
Because they work well at high frequencies. Actually, they also work well at low frequencies, but why use an expensive PIN diode when a cheap FET would do.
Is the 2N5777 photo diode an APD or a pin diode?
The 2N5777 is a Darlington silicon NPN photo detector, or, if you prefer a photoDarlington. A link is provided to a bit of data on this device.
My 2000 Nissan Altima has a relay at the ECM How do I check this 4 pin relay 1 and 2 is resistance and 3 and 5 are normal open The socket has a 12 vdc wire?
to properly test relay you must have relay in circuit apply voltage to pin 1 if there is no diode there will not be a polarity issue. if there is a diode you must apply voltage to proper pin or you will have a short circuit. apply ground to pin 2 with coil energized there will be continuity across the other pins when voltage or ground is denied there will be no continuity. to properly test relay you must have relay in circuit apply voltage to pin 1 if there is no diode there will not be a polarity issue. if there is a diode you must apply voltage to proper pin or you will have a short circuit. apply ground to pin 2 with coil energized there will be continuity across the other pins when voltage or ground is denied there will be no continuity.
Why is Avalanche photo diode used when compared to PIN diode?
The output current of a PIN diode is proportional to the light incident . Whereas in APD due to internal multiplication (Avalanche multiplication) of primary photocurrent, higher gains are possible. A small signal current output from the pin diode are to be amplified before applying to next associated receiver circuit. This includes thermal noise in the main signal, giving lower, receiver sensitivity. In case of APD, photocurrent is multiplied before encountering the thermal noise amplifier, giving increased receiver sensitivity.
Why in 8085 36 pin has barr?
Pin 36 on the 8085 is RESET-IN/. There is a bar (/) to indicate that this is a negative logic (low=true) pin. Typically, you connect an RC network to pin 36 (1uF to GND, 75KOhm to Vcc, and small signal diode (1N914) across the capacitor with anode on pin 36) which creates a reset pulse at Vcc power on. The diode is used to force discharge on power off, ensuring a reset sequence when power glitches.
What is the fullform of CNF?
What is the fullform of CNF?
What is fullform of jrg?
jrg fullform
What is the fullform of HFS?
What is fullform of hfs
