Put the jumper clip on different pins
It consists of adding, removing or repositioning a metal clip to obtain the needed setting.
You can watch the movie jumper in the movie houses, in DVD's or in the internet.
The only setting that the technician should change is the 'location of the swap file'
A jumper is closed (on) if the cover is in place, connecting the two pins that make up the jumper; a jumper is open (off) if the cover is not in place.
A jumper is used to complete a circuit on a motherboard or other device and thus signal a certain mode of operation, such as "the BIOS should be in recovery mode" or "this hard drive is the Master device."
It consists of adding, removing or repositioning a metal clip to obtain the needed setting.
"Jumper Parking" is when you have a Jumper hanging on one pin for safe keeping, rather than using it to turn a Jumper Setting on.
NO!
Parked
This is a common practice. It causes no harm, and you have the jumper handy when you need it! It is called a Parked Jumper.
The function of cable select jumper setting is to let the cable select which drive takes priority ("master") and which one comes after ("slave").
camera
Different jumper settings on a motherboard connect different circuits and processes. Check the motherboard documentation to see which jumper setting is correct for your application. Use caution, because incorrect jumper settings may harm the motherboard.
Go the website of the company that manufactured your drives. Find the correct jumper settings and set the jumper for the one you want as master at the master pin and plug the main IDE cable into it. if you want to run the other as slave, find the correct jumper setting for slave, then plug the second IDE cable into it.
SCSI Channel
Hi no you don't need setting jumper for install, just apply the termal material on the heatshik an CPU tha'it.
Put the jumper clip on different pins