RIP VERSIONV1 can be seen to exclude subnet information from routing updates, this is because ripv1 is a classful routing protocol and does not support VSLM, this was corrected in RIPv2 where ripv2 does send out subnet mask's in the form of a prefix eg /24 which is the subnet mask of 255.255.255.0 or a class c address.
OSPF is a classless link-state routing protocol. RIP version 1 and IGRP are both classful distance vector routing protocols, EIGRP is a hybrid protocol that supports classless addressing.
Dynamically, as related to a routing protocol is a type of networking technique whereby the routing protocol creates, updates and maintains the dynamic routing table.
RIP is a routing protocol - a protocol (set of rules) that allows a router to exchange information, with other routers, about existing routes.
RTMP- Routing Table Maintenance Protocol.
RIPv2 sends subnetmasks in the routing table updates. RIPv1 does not, which causes it be class-full.
RIPv1 RIPv2
RIP VERSIONV1 can be seen to exclude subnet information from routing updates, this is because ripv1 is a classful routing protocol and does not support VSLM, this was corrected in RIPv2 where ripv2 does send out subnet mask's in the form of a prefix eg /24 which is the subnet mask of 255.255.255.0 or a class c address.
Routing Information Protocol (RIP) and Interior Gateway Routing Protocol (IGRP) are two very popular Distance Vector routing protocols
EIGRP
IP, Enhanced Interior Gateway Routing Protocol (EIGRP), Serial Line Interface Protocol Frame Relay, Routing Information Protocol Version 2 (RIPv2),VLANs, Ethernet, access control lists (ACLs).
RIP V1 dose not support CIDR or VLSM as it a clasfull routing protocol that dose not include the subnet mask.. however if you were to use RIPV2 you could use static routing with it as it is a classless protocol and dose incoperate the subset mask in the update
Classful vs. Classless RIPv1 is a classful protocol, meaning that the subnet mask is not included in the routing updates. With RIP, only the default subnet mask is used to identify networks. RIP v2 is a classless protocol, meaning that the subnet mask IS included in the routing tables.. RIPv2 supports variable subnet masks (VLSM).
RIPv2 and EIGRP
It is a Hybrid routing protocol. It provides configurable metrics. It establishes formal neighbor relationships among routers.
A network administrator needs to configure a single router to loadbalance the traffic over unequal cost paths. Which routing protocol should the administrator use? ** RIPv2
OSPF is a classless link-state routing protocol. RIP version 1 and IGRP are both classful distance vector routing protocols, EIGRP is a hybrid protocol that supports classless addressing.