0
What else can I help you with?
What is three basic parts of a computer?
Processor ports and monitor
What are the examples of serial and parallel ports?
give the difference between serial port and parallel port
What are the different external parts of c.p.u.?
Casing CD-ROM/DVD ROM Floppy Disk Drive LED Reset Ports Power
What is difference between dynamic and volumetric compressor?
what is difference between dynamic and volumatic compressor
What are On-board ports?
Ports on the mother board.
What is the difference between ports cables and connectors?
you don't have to look for a connection with the ports
What is the difference between a docking station and a port replicator?
A docking station has fewer ports.
What is the difference between a mediport and an infusaport?
the brand. Both are ports manufactured by different companies.
What is difference between modular or non modular router?
additional ports can be added in modular routers.
Is there a difference between afterwards and afterward?
No difference, just from different parts of the country.
What is the difference in quality between O Reily automotive parts and those from Auto zone?
There really isn't much difference between O'Reilly automotive parts and those purchased from Autozone. They are both after market parts manufacturers, as opposed to OEM parts manufacturers. The pricing is fairly similar, so there really isn't much difference between the two brands of parts.
What's the different between an Ethernet bridge and a switch?
The difference between an ethernet bridge and a switch is that the bridge only has two ports, while the switch has multiple ports. When there is a lot of traffic going through the ports, the bridge traffic may get tied up or crash often because there are only 2 ports for information to travel back and forth.
What is difference between parts and spares?
parts are used,spares are extras kept to replace parts when needed
What is difference between valve and port?
valves are use in four stroke engine, and ports are use in two stroke engine.
What term describes the difference in elevation between the highest and lowest parts of an area?
The term that describes the difference in elevation between the highest and lowest parts of an area is "relief."
What is the difference between 1800cc and 2500cc engine?
The difference is in the size of the engine. Specifically in the intake and exhaust ports. The bore and stroke of the crank and pistons and the size of the combustion chambers.
What temperature difference should be expected between the indoor line and the permanent suction -line ports on the reversing valve during the cooling cycle?
During the cooling cycle, a temperature difference of around 18-20°F is expected between the indoor suction line and the permanent suction line ports on the reversing valve. This temperature difference indicates proper operation of the system.
