It is a passive electrical device with a resistive value of 1000 ohms, used for limiting current or dropping voltage.
1000
Divide by 2 repeatedly and the answer will be revealed!
-------------[_________]-------------- and put a line on the top of the box
General purpose resistor is used to resist the current flow.the common resister is general purpose resister.
Process
Yes. You can use a voltage divider. Say, for instance, one 1KOhm resistor in series with a 3KOhm resistor. Connect the 3k resistor to the 48 volts and connect the 1k resistor to ground. The 1k resistor will have 12 volts acress it. These resistors need to be at least 1 watt each as they are going to dissipate 0.576 watts and get warm. Now, if you attempt to pull power from the 1k resistor, note that regulation will be poor because the impedance of the load will go in parallel with the 1k resistor and change its value.
the k is the Metric value kilo, or ,1000 so this is a 1000 ohm resistor
Its dependent what will by rated power of the device (current).
It depends on the current going through it. Ohm's law: Voltage equals current times resistance.
The range of resistor value typically used in water level detectors is between 1k ohm to 100k ohm. The specific resistor value depends on the sensitivity required for detecting the water level change. It's important to choose the resistor value that provides a balance between sensitivity and stability in the detector circuit.
A preset resistor also known as a poteintometer is a type of resistor whos resistance is selected by the user. A preset maybe of any range i.e. from 1k to 100k or from 1M to 100M. a preset is used in many circuits where varyin resistance is required
1K
The voltage going into each parallel node will be equal to the voltage of the node before it, as long as the resistance is the same. For example, if you have a current of 5 volts split between two 1k ohm resistors, each 1k ohm will have 5 volts before the resistor drops the voltage.
1000
'1K' is an abbreviation for 1000 (one thousand). It could be 1000 of anything.
1k = 1,000 so 50k is 50,000
52 x 1K ohms + or - 10%. (Plus or Minus is represented by a + sign with a - sign directly under the +) Like this ±