0
What else can I help you with?
Which one of the following is useful in debugging a program that communicates via a network?
Logic probe(not sure)
What is an ammprobe?
Did you mean amprobe? In electronic engineering a current clamp or current probe is an electrical device having two jaws which open to allow clamping around an electrical conductor. This allows the electrical current in the conductor to be measured without having to make physical contact with it or to disconnect it for insertion through the probe.
How do you calibrate a RTD?
A Resistance Temperature Detector (RTD) is a device with a significant temperature coefficient used as a temperature measurement device, usually by passing a low-level current through it and measuring the voltage drop. To calibrate, refer to the manual for specific instructions. In general the steps include placing the reference probe and the UUTs in the temperature source in close proximity to one another, connecting the leads to the readout, and measuring the reference probe and determining the temperature.
How can you determine the level of liquid without making any cintact with it using any probe?
By differential pressure of the liquid and the air gap above the liquid. Both the pressures are given to the differential pressure transmitter, and the signal received from the transmitter is then converted into level using conversion factors supplied by the supplier of the transmitter.
What does manmade mean?
made by mannot by machinery.
When was the probe made?
problely about in 1969
In 1976 what country's probe made a soft landing on mars?
The US landed the Viking probe.
What USSR space probe that landed on the moon?
The first man-made object to reach the moon was the Luna 2 probe in 1959.
Was there ever a 8 cylinder engine made for a ford probe?
No
Why did Patricia Bath make the Laserphaco Probe?
She made it to remove cataracts
How was the death probe built in six million dollar man?
I snuck on the lot of universal studios in 1979 and I saw the death probe sitting there and I ripped off one of the spikes on the probe. It was a great sovinier . It was made out of rubber.
What is a microelectrode probe used for during a pallidotomy?
Once the burr hole is made, the surgeon inserts a microelectrode probe, which is used to more precisely locate the GPi.
What is the probe size?
Probe,probe se 2.0 / probe gt 2.5
What fascinating discoveries did the space probe make when it encountered a planet inhabited by creatures that reproduce?
The space probe made fascinating discoveries when it encountered a planet inhabited by creatures that reproduce.
When was the first moon landing by space probe?
On February 3rd, 1966 the Soviet unmanned spacecraft Luna 9 was the first man-made probe to make a soft landing on the moon.
How is a radioactively labeled probe made?
A radioactively labeled probe is made by attaching a radioactive isotope to a nucleic acid molecule, such as DNA or RNA, which is complementary to the target sequence of interest. This is typically done by incorporating the radioactive nucleotide during the synthesis of the probe or by labeling the probe post-synthesis through various chemical methods. The choice of isotope, such as phosphorus-32 or sulfur-35, depends on the specific application and detection requirements. After labeling, the probe can be used in techniques like hybridization to detect specific nucleic acid sequences in various biological samples.
How difficult is it to replace the starter in a Ford Probe It's a 1985?
Probes were not made until 1989
