To get your computers local network IP address, subnet mask, and default gateway typing ipconfig alone will display this information as shown below:
ipconfig
Ethernet adapter Local Area Connection:
Connection-specific DNS Suffix . : hsd1.ut.comcast.net.
IP Address. . . . . . . . . . . . : 192.168.201.245
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . : 192.168.201.1
ipconfig /release
ipconfig /renew if you're on windows
Ipconfig shows IP address, Subnet Mask, and Default gateway for all adapters. Ipconfig /all shows the description of each network connection along with additional information such as your physical (MAC) address, DHCP connections, Lease times, as well as in-depth IPv6 information.
Ipconfig and Ping both are commands of command line interface (CLI) .IPconfig is used to display all network configuration values . Ping is used to check whether a host can send or receive packets.
Open command prompt and simple write "ipconfig" and press enter. Note: Do not use colons "" Just use ipconfig
No, it will work on dynamic too.
ipconfig /release is the full command line.
assuming that by down you mean get... ipconfig if you want all ip settings then ipconfig /all command ipconfig If you mean to disable or turn off the ip to disconnect from the internet then ipconfig /release
IPConfig is an application in Microsoft. IPConfig displays all current network configuration values and can be used to modify a variety of network settings.
ipconfig/release and ipconfig/renew
ipconfig
ipconfig /renew is used to renew your DHCP IP address after releasing it with ipconfig /release. If no adaptor is specified, all adaptors are renewed.
ipconfig /all
ipconfig /release
Ipconfig is used to show all current TCP/IP network configurations values and connections in Microsoft Windows. It is a command line tool.
ipconfig /release
ipconfig /release