Preparation of standard solution and standardization of hydrochloric acid Objective : To prepare a standard solution of sodium carbonate and use it to standardize a given solution of dilute hydrochloric acid. Introduction : Anhydrous sodium carbonate is a suitable chemical for preparing a standard solution (as a primary standard). The molarity of the given hydrochloric acid can be found by titrating it against the standard sodium carbonate solution prepared. The equation for the complete neutralization of sodium carbonate with dilute hydrochloric acid is Na2CO3(aq) + 2HCl(aq) → 2NaCl(aq) + CO2(g) + H2O(l) The end-point is marked by using methyl orange as indicator. Chemicals :solid sodium carbonate, 0.1 M hydrochloric acid
ARP
The Internet Protocol (IP) is a network protocol that specifies how messages or data are sent between two points on a network. IP is in charge of addressing and routing data packets, making sure they travel across linked networks to the right place by adhering to predetermined routing rules.
ARP and RARP protocols are present at network layer. ARP is short form of address resolution protocol. IP is the type of header an ARP frame contain .
The purpose of the FCS field is to transmit the extra checksum characters added to a frame in "xyz" protocol for error detection. The most popular algorithm I've used is the CRC (cyclic redundancy check) employed in things like ethernet or PPP on a routed network. Keep in mind that ethernet defines that the errored frame should be discarded, but ethernet takes no action to cause the frame to be retransmitted. Typically most tech's see it as unnecessary overhead and opt to rely on CSMA\CD or CSMA\CA if the route is not deemed to carry time sensitive data. Hope that clears things up a bit.
There are a number of technologies that can provide IPv6 translation for IPv4 users, most commonly Dual Stack and 6 to 4 tunneling. DUAL STACK involves running both IPv4 and IPv6 on a single router with the router managing the implementation of either protocol as and when necessary. 6 to 4 tunneling encapsulates an IPv6 frame in and IPv4 frame for tansport over an IPv4 network either to its destination address or a network where the IPv4 frame can be discarded.
The serial port must be configured for speed, parity type, character frame and protocol.
IP, Enhanced Interior Gateway Routing Protocol (EIGRP), Serial Line Interface Protocol Frame Relay, Routing Information Protocol Version 2 (RIPv2),VLANs, Ethernet, access control lists (ACLs).
frame
It is a frame structure because it is a frame structure.
Yes, It is a frame structure.
Depends on the protocol.
A tent is a frame structure
frame structure
It is a frame structure because the chair has a skeleton therefor it is a frame structure
The Remote Frame Buffer protocol is an application level protocol used by VNC applications to transmit information about the remote machine's desktop in order to re-create it locally. RealVNC explains the protocol here: http://www.realvnc.com/docs/rfbproto.pdf .
in frame structure the distributions of load is equal.... the best example to understand about frame structure is spider web.... it is a natural open frame structure
The serial number is on the frame.