0
loss of signal and data
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What are Potential problem with daisy-chaining hubs on a 10BASE-T network?
exceeding the maximum network length network + guide to networks Chapter 5 Review Question 6
What are the types of USB generic hubs?
what are some types of generic usb hubs
What can bridges do that hubs and repeaters cannot do?
Bridges send information (data) to the specified destination, whereas hubs and repeaters do not.
What is the most common central device used today to connect computers to a network?
Routers, Switches, Modems, and Hubs, but mostly Routers
Connectivity devices such as hubs and repeaters operate at which layer?
Hubs and repeaters operate at the Physical Layer of the OSI Model. The Physical Layer is the first layer of the OSI Model.
What is a potential problem with daisy-chaining hubs on a 10base-T network?
exceeding the maximum network lenght
Which of the following is a potential problem with daisy-chaining hubs on a 10BASE-T network?
Exceeding the maximum network length
What is the potencial problem with daisy-chaining hubs on a 10base-t network?
Pangit ka
What are Potential problem with daisy-chaining hubs on a 10BASE-T network?
exceeding the maximum network length network + guide to networks Chapter 5 Review Question 6
Can you daisy chain USB hubs?
Yes. USB can support 127 devices per port which allows for daisy chaining.
What is the maximum number of active hubs or repeaters that can be linked in a daisy-chain configuration?
10
1994 ford ranger 4wd front hubs won't lock in?
the hubs are bad buy new ones i had the same problem
How do I add more computers if my Network Hub is out of connectors?
You can always daisy-chain hubs by attaching themselves to each other.
Name two situation in which a crossover cable would be used to connect devices?
A cross-over cable is used to connect two computers together without the use of a connecting device, such as a switch or hub. When daisy-chaining hubs and switches, some older equipment has a special port called the up-link port. This port requires the use of a cross-over cable to add hubs to hubs, etc.
You have an 82 Chevy half ton 4X4 with a grinding noise in the front axle only with both hubs locked and hard braking but with either hub unlocked there is no sound what could it be?
check the manual locking hubs or the u joints and had the same problem and it was the hubs
How many devices can be connected to a USB port in asystem?
Typically? One. However with use of hubs and chaining devices, theoretically one could have up to one hundred and twenty seven devices. In practice this might not work too well. Hope this helps!
How do you get the auto locking hubs on your ford f-150 to unlock?
There could be a mechanical failure or the hubs could be jammed with dirt and mud. They will most likely need to be taken apart to see where the problem is.
