In a Voltage Shunt feedback Amplifier, the feedback signal voltage is given to base of transistor in shunt through a feedback resistor.This Shunt connection decreases the input input impedance and voltage feedback decreases the output impedance.
In this amplifier input is current and output is voltage. Thus Transresistance is stabilized.Input and Output impedances are reduced by a factor of 'D'(desensitivity factor).
Advantages:
1)Gain independent of device parameters.
2)Bandwidth increases.
3)Noise and non-Linear distortion decrease.
4)Prevents Loading effect.
5)Acts as good source for the next stage.
resistors in series
Transformers use magnetic induction between 2 coils of wire to produce a voltage in the secondary winding. Typically the main purpose of a transformer is to step up or down the voltage by having differing number of windings between the primary and secondary coils. A secondary effect is to keep the 2 systems electrically isolated from eachother. If one of the phases becomes grounded, the ground is only seen on the portion of the system downstream of the transformer, thus increasing relibability.
a computer is what?? it is simply a machine made of hardware??but why we need computer....the answer is we need computer to perform computation on a specific task....how this computation will occur in the computer is defined by a set of rules ...to understand these rules ,we need to study theory of computation.... theory drives practice and practice drives theory....to make efficient machines for computation tasks we need to study theory of computation.
The theory of comparing light movement to dropping a pebble into a pond is called light refraction.
nowhere
An electrical amplifier amplifies 2 physical quantities according to the transistors used. If a BJT is used it amplifies the current and if a MOSFET is used it amplifies the voltage. Hybrid amplifiers amplify current as well as voltage so in theory , current voltage and power is amplified.
Wai-Kai Chen has written: 'Passive andactive filters' -- subject(s): Electric filters, Design and construction 'Broadband Matching, Theory and Implementations' 'Passive and active filters' 'Active network and feedback amplifier theory' -- subject(s): Feedback amplifiers
in series you XL, voltage leads the current, and in Parallel current leads the voltage. so your answer should reflect on this theory.
In a two stage RC coupled amlifier the rransistor are identical and a common power supply is used. the output is provided to the first stage of the amplifier wher it is amplified and this output is uses as a input for the sexound stage this is amplified once again by the other transistor in the sexound stage and the final out put is obtain.
James Chester Looney has written: 'The Galaxy memory system' -- subject(s): Computer storage devices 'Non-saturating amplifier theory' -- subject(s): Feedback (Electronics)
In theory it will be zero, in real life it's 0,003-0,005volts. Because the rule of ohm says: U = I * R. Shorted means that R = (almost) 0 so U will be close to zero too.
conventional theory is pos to neg. electrical theory is neg to pos.
With higher temperature, low voltage
Percival Hudson Hammond has written: 'Feedback theory and its applications' -- subject(s): Feedback control systems
constructivism
A transistor
James M. Ooi has written: 'Coding for channels with feedback' -- subject(s): Coding theory, Algorithms, Feedback (Electronics)