What two voltages are present on a peripheral power connector?
An ATX power supply unit delivers power in three voltages: 3.3 volts, 5 volts, and 12 volts. The 3.3 volt pins are used only in the motherboard connector. Older, AT power supplies and motherboards used only 5 volt and 12 volt pins in the motherboard connection.
A Berg connector is used for providing power to floppy drives and sometimes other peripherals.
A technician is installing a new power supply in a computer Which type of power connector should be used to connect to a PATA hard drive?berg mini-molexmolex.20-pin ATX connector
If the peripheral component draws power from the PC then that could relate to a problem on the PC. If it draws power from the same extension and the things in that extension are drawing too much power for the extension then that could also affect the PC.
Yes, -5 is one of the voltages a power supply puts out.
yellow in 12v red is 5v black in ground
12v, 3.3v 5v
No FireWire does not need a separate power supply to operate. FireWire is used to connect peripheral devices to a computer.
Your power supply unit, PSU. Takes AC power and distributes so much power to each connector. Each PSU, depending on the wattage of the unit gives each connector so much voltage. Each connector is designed for a certain piece of hardware that requires different voltage.
Typically, CD-ROMs are connected using a power connector called a Molex Connector. A Molex Connector has four wires, two for power, the other two for grounding. This connector supplies two different voltages to the device it is connected to - 12v and 5v. For more information on Molex Connectors, see the article here: http://en.wikipedia.org/wiki/Molex_connector#Disk_drive_connector_.28AMP_Commercial_MATE-N-LOK.29
The internal power connector supplies both 12v and 5v connections. CD ROM drives may use one or the other, even sometimes both voltages to power the individual components of the drive.
Harmonics is electric current or voltages that are part of the power system as a result of nonlinear electric loads. If there is no load and a harmonic is present it can present because of a rectifier in the system.
Power lines run at high voltages to overcome line loss.
There are two kinds in common use:Molex - an older standard, but still commonSATA - Serial ATA, a newer standardSee the related links for pictures.
The purpose of a 4-pin auxiliary connector on a motherboard is to provide an additional 12V power supply to the processor.
A typical motherboard contains the CPU, memory, storage, ROM BIOS, Southbridge and Northbridge chipsets, cooling fans, peripheral connector slots, connectors for peripheral devices, the battery backup and the power connector.
the regular ATX has a 20 pin power connector, while the enhanced ATX power connector has 24 pin power connector.