You configure them in the local network connection properties dialog box.
ndis defines parameters for loading more than one protocol on a network adapter
protocols
-Programmed services and protocols that move the messages across the network -Technologies that support network communications
No, the NIC will automatically install its own protocols and use them if needed
Network Layer
I donno
Mske sure the network is set up Correctly and that the Network adapters have the newest and correct Drivers installed.
On a Mac, as on everything else, PPPoE is used to configure Point to Point Protocols over Ethernet which allows communication between computers connected on an Ethernet network.
Opnet from www.opnet.com or NetSim from www.tetcos.com
VLAN
ndis defines parameters for loading more than one protocol on a network adapter
In a computer network, the network interface card (NIC) is responsible for transmitting and receiving data. The transmission characteristics, such as speed, duplex mode (full or half), and supported protocols, are maintained by the NIC's drivers and firmware. Adapters (physical or virtual) help connect the NIC to the network medium, such as Ethernet cables or wireless signals.
protocols used for network device.
You can go and buy a wireless network adapter at Wal-Mart wherein they offer you different brands of wireless network adapters. You can also buy such network adapters at www.amazon.com, www.bestbuy.com.
You don't need to configure UDP; this is done automatically by the application protocols that use this transport method.
Put the NIC in the PC, and install the NIC's drivers. Configure the NIC using Windows, so that it has the appropriate addresses on the network and the correct network protocols. Test the NIC to verify that the PC can access resources on the network.
Routed protocols are the best paths in a network along which to send network traffic.