In high-performance memory systems these decoders can be used to minimize the effects of system decoding. When used with high-speed memories, the delay times of these decoders are usually less than the typical access time of the memory. This means that the effective system delay introduced by the decoder is negligible. The DM74LS138 decodes one-of-eight lines, based upon the conditions at the three binary select inputs and the three enable inputs. Two active-low and one active-high enable inputs reduce the need for external gates or inverters when expanding. A 24-line decoder can be implemented with no external inverters, and a 32-line decoder requires only one inverter.
harmonics reduced due to multi switching and output is approximately sine wave so filter design and cost reduced.DC link voltage is also reduced because of splitted source.
Really there are only a few specific ones: Motherboard that takes the hardware CPU for the core processing Memory for relaying info Hard drive to store the info Video chip or card to display the video output optional: Sound chip/card for sound output
You might be talking about the BIOS, the Basic Input Output System stored on a ROM chip on the Computer Mainboard. It is the initial boot code run by the pc.
it's a motherboard sound chip.
The BIOS chip is located on the motherboard
Output in watts.
We cannot connect the 74ls138 straight with a seven segment display; for that we need a 7447(7 segment driver).
it is the video output chip
Inverter efficiencies vary about 50% when a small about of power is being used, to over 90% when the output is approaching the inverters rated output. Your question cannot be answered without knowing the inverters rated output.
Yes, two inverters can be connected together to increase output, but this must be done carefully to ensure they are compatible. The inverters should be designed for parallel operation, which allows them to synchronize and share the load effectively. It's important to follow the manufacturer's guidelines and use appropriate wiring and safety measures to prevent issues like phase mismatch or overload. Proper installation and configuration are crucial for safe and efficient operation.
Input! x
The possessive form of the plural noun inverters is inverters'.
Bios chip
The 74LS138 is a 3-to-8 line decoder that takes 3 input binary signals and activates one of eight output lines based on those inputs. It features three select inputs (A0, A1, A2) that determine which output (Y0 to Y7) will be low (active), while all other outputs remain high (inactive). The decoder also has enable inputs to control its operation; if the enables are not activated, none of the outputs will be activated. This device is commonly used in memory address decoding and data routing applications.
It's an IC where the input is a 3 bit binary number. The output has 8 pins, one for each of the possible input values. For example, if the input is 000, the output pin called Y0 will the activated because that cooresponds to zero while all other pins will stay the same.
ROM
Basically there are three types of inverters 1) Square wave Inverters 2) Quasi Square wave or Modified Square wave Inverters 3) True/Pure Sine wave Inverters The emerging trend among Inverters could be titled to Multi-Level Inverters which aim at the Increasing of Inverter Efficiency along with reduced Inverter Cost