answersLogoWhite

0

What else can I help you with?

Related Questions

Is a thumb pin an insulator?

If thumb pin means the same as what I call push pins then the plastic handle is an electrical insulator but the pointed metal pin itself is not.


Why pins have pointed end?

The sharp points makes it easier to push the pins into material.


No grip and pins and needles in hand?

i have nogrip in both hands and pins a niddles in thumb and first 3 fingers


How many pins does pinhead have in his head?

there are 130 pins


What pins are you supposed to target for a first ball?

Right Handed Shot, target the one (head) and three pins Left Handed Shot, target the one (head) and two pins


Can TSA allow pins to go through security screening?

Yes, TSA allows pins to go through security screening as long as they are not sharp or pointed enough to be considered a potential weapon.


When two pins are hung by their heads from the same poles of a magnet their pointed ends fly apart Explain?

The ends of the two pins represent two poles of the same polarity, which means they repel each other.


How do you take the pins out of the brake caliper on a 1994 Ford Escort?

Use a nail or small pointed item and a hammer. That's how I did mine


What causes pins and needles in your head?

Pins and needles sensation in the head, also known as paresthesia, can be caused by various factors. It may occur due to nerve compression or irritation, such as from poor posture or tension in the neck muscles. Additionally, conditions like migraines, multiple sclerosis, or even anxiety can also lead to this sensation. It is essential to consult a healthcare professional for a proper diagnosis and treatment if you experience persistent pins and needles in your head.


How does the pins work?

The safety pin has a pin that goes into the head of the pin, and you push the point in or out of the head of the pin.


How do you hold down a head gasket while putting the head back on?

it stays on , it has dowel pins sorta to guide head and hold gasket


What toolis required to remove the caliper bolts There is no bolt head?

might just be pins