0
What else can I help you with?
What is a duct house?
House made of duct tape. I wouldn't reccomend it.
What programming language has been called the duct tape of the Internet?
The answer is: Perl.
What is the hardest song in all of tap tap revenge?
House Music by Benny Bennassi on expert level it is actually duct tape smile by Psyopus which is nearly impossible
Where is the pcm on a 2001 Saturn l series?
If its not under the hood behind the battery . The whole top part or your dash comes apart and is located behind the cluster panel . The PCM is located behind the glove compartment(the G.C.lid would have to come off-unscrew the spring loaded hinge at the bottom of it)) The connector with cables comes in from the engine compartment.The cowel (the plastic cover with many holes of the area right bellow the windshield) has to be removed by partially removing windshield's bottom trim. 4 screws hold down rubber boot of the cables and then 2 more screws hold the connectors securely to the body of PCM. The PCM need to come out through glove compartment after disconnecting cables. First there is 1 plastic pin, holding air duct to the PCM. Pin head is on the bottom of the duct at the end of it. Just pull it down and out. PCM is inside plastic"envelope",which needs to be loosened(2 screws on sides towards the top of PCM-looking through glove compartment opening. Further there are 2 plastic tabs behind the metal ears for screws ,which needs to be depressed towards the center of of PCM.(use small screwdriver or allen wrench or just small metal or hard plastic rod. Then it just drops down(not coming up through the hole!)Before pulling it out you will also need to disconnect the ECM, which is attached by 2 tabs to the PCM plastic"envelope"(i.e. cover box). ECM is much smaller and has like 3 smaller connectors-no need to disconnect that. P.S. Unless you are sure,the PCM is bad and you need to change it, do not pull it! It can be flashed,but it must be in the car. Cannot be flashed loose out of vehicle!
What is the working principle of convergent-divergent nozzle?
A NOZZLE IS A DUCT WHICH CONVERT HEAT ENERGY INTO KINETIC ENERGY.IT INCREASES VELOCITY OF FLUID PASSING THROUGH IT ,AT THE EXPENCE OF PRESSURE. STEAM EXPANDS IN NOZZLE FOLLOW RANKINE CYCLE.FLOW THROUGH NOZZLE IS ISENTROPIC. mritunjay04@gmail.com
How do you protect cable from animals?
There are a few ways to protect cables from animals. One way is to cover the cables with duct tape.
Why doesn't your apartment have duct work?
If your apartment does not have duct work, the owner of the building has not had it installed. Perhaps they felt it would be too costly to install, or perhaps they are simply not interested in or see a need for duct work.
Where is the IAT sensor on 1993 Nissan Maxima?
The IAT sensor is installed in the intake air duct
When one performs cable jetting what is one doing?
When one performs cable jetting, it usually refers to someone is setting up the cables. The cable jetting is a method, where the cables are pushed into a duct.
What is the root word in deduction?
The root word is duct (a tube in a building, usually for ventilation, water pipes and electrical cables, etc).
What are the essential duct work tools needed for a successful HVAC installation project?
The essential duct work tools needed for a successful HVAC installation project include duct tape, tin snips, duct sealant, duct insulation, duct hangers, and a duct crimping tool. These tools are necessary for cutting, sealing, insulating, hanging, and connecting ductwork in a HVAC system.
Where is the intake-air-temp sensor on a 1997 Nissan Maxima?
The IAT sensor is installed in the intake air duct
It is possible to get a central air conditioner installed in my 1900 victorian home?
Of course it is. The unfortunate part is that because it is so historic, you will have to new duct work installed, which will cost you a lot of money.
Is there a special kind of duct work needed when installing a new furnace, when using an I-beam for the floor joist Does the steel I-beam have anything to do w/what kind of duct work is installed?
The duct work does not need to be different from the rest just because of the I beam. Just be sure there is room so you do not compress it.
Can you use duct tape instead of gaffer tape for securing cables to a floor?
Yes you could bt I wouldn't reccommend it because it will leave stickies on the floor.
What the uses of bus duct?
Busduct is useful for transforming current from switchgear end to transformer end.It has no voltage drop.But little bit expensive when compared to Cables.
What kind of equipment is necessary for air duct cleaning?
Air duct cleaning simply requires a screwdriver, heavy-duty gloves, a cleaning brush, rags, and a vacuum cleaner, though hiring a professional is recommended in order to avoid damage to the air duct.
