0
What else can I help you with?
Why does the switch between Host and the router not require configuration with an IP address to forward packets?
If a switch is connected to a router then the MAC address of the router is known to the switch through that port. A host takes advantage of this by using the default gateway address (the address of the router) which the switch "knows" by its lookup table. Therefore, the switch can learn the address automatically and no configuration is necessary.
Does it matter when snowboarding if you switch the foot forward?
no.
What is A switching mode in which a switch reads a frame's header and decides where to forward the data before it receives the entire packet?
Cut-through mode.
Can you use a 10 100 desktop switch to conneck to anothor computer connection?
yes as long as you have a router the router will allow for more than one computer to get an ip address and distribute them through the switch allowing for more computers to connect to the internet
What device cannot forward the broadcast traffic?
switch
What is the function of the furnace fan switch and how does it impact the operation of the heating system?
The furnace fan switch controls the fan that circulates air in the heating system. When the switch is turned on, the fan starts blowing air through the ducts to distribute heat throughout the home. If the switch is off, the fan will not operate, which can affect the efficiency of the heating system by not distributing heat evenly.
How do you wire a garbage disposal between the disposal and the GFI?
White and the ground go to the disposal, black goes through a switch and then to the disposal. All three go through the switch box, the white and ground just pass through on the way to the disposal. Break the black with the switch.
What switch mode offers minimum latency?
Cef (cisco express forwarding)
How do you replace a 2001 Mazda millenia sunroof switch?
There is a spring clip under the front of the switch. Push a thin blade between the front of the switch housing and the roof padding and you can pull the front of the switch down. The housing should pull out forward as the back of the housing is held up by a plastic tab.
Why will my club cart golf cart go in reverce and some times it will not go in forward gear?
You must have a loose, damaged, or touching wire either on the battery or on the switch that switches between forward and reverse.
How does a p-n junction diode work as a switch?
diode conducts in forward bias.so it is on switch. in reveres bias it will not conduct.so it is off switch
Different types of switches used in computer networking?
Ethernet switch,cut through,crossbar,cell backbone,store and forward, back presser, atm, LAN
