0
What else can I help you with?
Which network topology requires the use of terminators?
The bus topology requires the use of terminators. In this topology, all devices are connected to a single central cable, known as the bus. Terminators are placed at both ends of the bus to prevent signal reflection, which can cause data collisions and network interference. Without terminators, the signals can bounce back along the bus, disrupting communication between devices.
At the ends of each bus network are 50-ohm resistors known as?
terminators
What is A cable with terminators at each end and is shared by all nodes?
Bus Cable
What is a cable with terminators at each end and is shared all nodes?
Bus Cable
A bus network would suffer from signal bounce without what?
a specific resistor/ capacitor circuit connected to a 555 timer will create a debounce switch in synchronous format
What is purpose of terminator on bus topology?
In a bus topology, the purpose of a terminator is to absorb signals at both ends of the bus cable, preventing them from bouncing back and causing network interference. Without terminators, signals could reflect back along the bus, leading to data collisions and communication errors. By ensuring proper signal termination, terminators help maintain the integrity of data transmission across the network.
Why terminators are used in a bus topology?
So that the Signal will not reflact back due to difference of permitivity of signals that causes destructive interfrance... They are used in End of Bus topology
How do you terminate a bus topology?
To terminate a bus topology, you need to install terminators at both ends of the main cable. These terminators absorb signals that reach the end of the cable, preventing reflections that can interfere with data transmission. Without proper termination, network performance can degrade due to these reflections, leading to data collisions and communication failures. Ensure that the terminators match the impedance of the cable used in the network to maintain signal integrity.
What is the purpose of terminator in bus topology?
In a bus topology, the terminator serves to absorb signals at the ends of the bus, preventing them from bouncing back along the cable. This helps to eliminate reflections that can interfere with data transmission, ensuring that signals travel smoothly along the bus. Without terminators, data collisions and network errors can occur, leading to unreliable communication. Thus, terminators are essential for maintaining network integrity and performance.
When are buses used in a computer?
Inside a computer, a bus transfers data between components. A bus is thought of as being the physical wires that make the connection, but these days the software that controls data transfer is also thought of as part of the bus.
WHAT IS A bus network?
Bus networks are usually based in a single room and look like such: _ _ _ Computers :-----------------: actual cable line and terminators (cables would goto the PCs) _ _ _ more PCs The medium is a coax cable (looks like tv cable) and requires terminators on both ends of the cable for stopping the resonence of the signal. All pcs are directly hooked into the coax cable and any break in the cable will result in complete network failure. Average speed was 10Mbps The computers required special network cards capable of hooking up to the coax cable, often refered to as a BNC connector.
What Is The Slowest Computer Bus?
The slowest computer bus would be a stopped or halted computer bus, since there would be infinite time between operations.
