0
What else can I help you with?
The SCSI ID identifies the logical device?
false
What SCSI ID is often used for a boot device?
The SCSI logical unit number for boot devices is almost always zero(0).Matt Friend
What is a task that you have to perform when installing SCSI devices?
Assign each SCSI device a unique ID number
How would an ID logical 3 be set on a three-bit jumper block on a SCSI hard disk drive?
011
Which scsi id number is recommended for the cd-rom?
ID3. Every other device can be set to any number as long as it's not in use. It is a recommended practice in IT comunity to set the scsi ID number for CD-ROM drive to 3.
What is purpose of SCSI?
It connects eternal device, connects power supply to analyze data.-Small computer system interface.-for peripheral devices connectivity (8 devices (0-7))-Internal and external buses like power supply and extensive peripherals.-Ultra SCSI - 32 devices (no wire is required, all with is uses is wireless).-Physical drive accession - (Single hard dish is physical drive).-Logical drive accession.-SCSI ID is available in the device.Configuration done in booting.-5MB/Sec.-SCSI: 2--Fast SCSI - 10MB/Sec.--Wide SCSI - 16bit 20MB/Sec.-SCSI: 3--Support 32 device - 40MB/Sec.Note: the above answer is in the form of points.
What is SCSI ID number for CD?
id 2
What is the scsi id for the CD-rom?
ID 3
What scsi id should be assigned to a scsi-2 adapter card in a computer?
The host adapter is assigned SCSI ID 7, which has the highest priority over all other devices.
How many devices can be connected in a SCSI chain (plain SCSI)?
In a plain SCSI (Small Computer System Interface) chain, up to 8 devices can be connected, including the SCSI host adapter. This means there are 7 additional devices that can be connected to the chain. SCSI IDs range from 0 to 7, with each device needing a unique ID for proper communication.
Which ID number is normally assigned to the SCSI controller?
The ID number which is traditionally assigned to the SCSI controller is ID 7. ID 7 is given the highest priority during bus arbitration.
What is the purpose of SCSI?
It connects eternal device, connects power supply to analyze data.-Small computer system interface.-for peripheral devices connectivity (8 devices (0-7))-Internal and external buses like power supply and extensive peripherals.-Ultra SCSI - 32 devices (no wire is required, all with is uses is wireless).-Physical drive accession - (Single hard dish is physical drive).-Logical drive accession.-SCSI ID is available in the device.Configuration done in booting.-5MB/Sec.-SCSI: 2--Fast SCSI - 10MB/Sec.--Wide SCSI - 16bit 20MB/Sec.-SCSI: 3--Support 32 device - 40MB/Sec.Note: the above answer is in the form of points.
