0
To determine switches in a domain, you can use network discovery tools or protocols like Simple Network Management Protocol (SNMP) to scan the network for devices. You can also check the domain controller’s Active Directory for registered devices or use command-line tools like arp, ping, or tracert to identify connected switches. Additionally, examining the network topology through documentation or network diagrams can help identify the switches present in the domain.
What else can I help you with?
Are devices in a single collision domain in the same broadcast domain?
AnswerYes. You can't split a broadcast domain without also splitting the collision domain. The only devices that can split a broadcast domain are routers and layer 3 switches. Switches, bridges, and routers can all be used to split the collision domain. Hubs and repeaters do not split the collision domain or the broadcast domain.
Switches can create by grouping a number of ports into a broadcast domain?
VLANs.
Which device extends a collision domain?
Bridge, Switches, Router.
How do routers and switches separate collision domains?
in my opinion there is no any collision domain in the router......but switch has collision domains for each interfaces & hub has one collision domain
How do you prevent collisions in a broadcasting domain?
You can't eliminate collision in a broadcasting domain. What you can do is to increase the number of collision domain within a broadcasting domain by using more switches. this will improve your network traffic because the more the collision domain, the better is your network in terms of data transmission performance.
How are vtp messages sent between switches in a domain?
Layer 2 multicast. vtp is stopped at the router.
This switch is to be added to the production network which facts about vlans and vtp operation can be confirmed by this output choose two?
All VLANs that are configured on this switch will be sent to all other switches in the same VTP domain. Adding this switch to the network will cause no disruption in the VTP domain operations if the rest of the switches in the same domain have a higher configuration revision number.
Which three VTP parameters must be identical on all switches to participate in the same VTP domain?
Three VTP parameters that must be identical on all switches to participate in the same VTP domain include domain name, domain password, and version number. VTP stands for VLAN Trunk Protocol. The answer can be found at http://www.ccna4u.org/2011/06/ccna-3-chapter-4-2011-v4-0-answers-100.html
What devices extend the size of a broadcast domain?
Layer 1 (hubs) or Layer 2 (bridges or switches) devices.
If hub is replaced with switch is there any changes in collision domain?
In most modern-day network switches, collision is no longer a problem. Network switches are good at handling these situations to avoid collision problems.
What do switches create when they group a number of ports into broadcast domain?
this would be called virtual local area connection or a vlan
The network administrator wants to configure a switch to pass vlan update information to other switches in the domain but not update its own local vlan database which two steps should the administrat?
Configure the VTP mode of the switch to transparent. Configure the switch with the same VTP domain name as other switches in the network.
