0
What else can I help you with?
Why would a floating static route be configured with an administrative distance that is higher than the administrative distance of a dynamic routing protocol that is running on the same router?
A floating static route is configured with a higher administrative distance than a dynamic routing protocol to ensure that it only takes effect if the dynamic route becomes unavailable. This allows the router to primarily use the dynamic routing protocol for its normal routing decisions, benefiting from its ability to adapt to network changes. If the dynamic route fails, the floating static route will then be used as a backup, providing a failover mechanism without disrupting the primary routing process.
What type of route is used when no routing protocol is configured?
Static routes
What are two reasons for the occurrence of a routing loop?
incorrectly configured static routesslow convergence
When are static routes used on a network?
to config a router manually
What do i do if my computer can't find my router. what do i do?
Was your router installed and configured by your Internet service provider ? Does it act as DHCP server ? Meaning does it assign IP addresses to connecting clients ? Is the network card on your Computer working ? In command mode (Microsoft windows) if you type ipconfig /all what do you get ? Is your computer network card configured to automatically obtain an IP address or does it have a static address ? If your network card has a static IP address, you should check that it is in the range of the DHCP server and that they both have the same subnet mask. You should change selection in propeties to automatically obtain IP address. Check then if you see your router. Afterwards you can reassign a static IP address in the appropriate range or change the range on the router. Does your computer see other wifi in range but not yours ? Can you connect to your router from another computer ? In that case, you should compare the settings of the network connection of both PC's. And settings of the cards (is the radio option on ?) Is the location of the router adequate to avoid obstruction or interferences ? Both reduce the range of wifi network equipment. Obstructions are walls, furnitures ... Interferences are microwaves, cordless phones ...
Routing is a technique in which a network administrator programs a router to use specific paths between nodes?
Static routing is a technique in which a network administrator programs a router to use specific paths between nodes?
How do you remove a static route from a routing table?
Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....
Differentiate between static and dynamic routing algorithms?
* Manually set up a route in a dormant manner. * Stable. * Has no impact made by traffic and transmission failures. * Creates no traffic derived from routing protocols. = dynamic routing: = * Automatically sets up a route. * Can respond to the changes of the network. * Can automatically select the optimized route. * Can automatically select the backup route.
What should you do if Router R2 is configured properly and all interfaces are functional Router R1 has been installed recently Host A is unable to ping host B?
Configure a static route on R1 using the IP address of the serial interface on R1. Configure a default route on R1 with the exit interface Fa0/0 on R1. Configure a static route on R1 using the IP address of S0/0/0 on R2. Configure a default route on R1 using the IP address of Fa0/0 on R2.
What does an ip address of 169.254.0.12 indicate?
Nothing. That is not a valid IP address as its stands however ip addresses with the first 2 octets of 169.254.xxx.xxx means that Automatic Private IP Addressing has been enabled because no DHCP server was found and no static address has been defined.
What TCP IP settings must be configured before installing the DNS server service?
You must set a static IP.
What is the routers command used to configure a static route for a router?
routing table code S
