take screws out and pull door trim off
# Remove the center console # Detach the retaining screws from the center trim panel.Disconnect any electrical connectors and remove the trim panel
It pull's off and snaps back on.
To remove the headliner on the 1998 Ford Escort, first remove both of the visors by removing their screws. Then, remove the trim from around the edges of the interior roof. Then, pull the headliner down from the ceiling.
yes , top can be removed. remove trim along bottom sides of top, also remove trim where front of top meets roof of cab then remove bolts that hold top to vehicle. then with some buddies, lift top off
remove the trim from the interior of the lift gate. There is access to the connecting rods that will release the catch from the Nader bolts.
remove the inside trim or cut a hole to reach the mechanism and replace the inside trim.
To remove the rear door trim from your 1999 Ford Laser KN hatch, start by carefully prying off any plastic covers or clips that may be hiding screws, usually located around the door handle and the edges of the trim. Remove the screws using the appropriate screwdriver, then gently pull the trim away from the door, starting from the bottom and working your way up. Be cautious of any remaining clips, and ensure you disconnect any wiring for speakers or controls before fully detaching the trim.
How do you get the door trim off a 1997 Ford Festiva?"
First, unscrew the gear knob and lift the trim from the back. Then, lift the gaiter and the trim away from the console plate. Next, remove the old gaiter from the trim. Finally, line up and connect the new gaiter to the trim and reconnect the trim to the console plate.
Remove the radio using Ford radio removal tool. Remove screws holding the trim to the left of the radio. Pop off the headlight knob. Pop out the headlight switch trim. That will expose the screws to the instrument gauge trim. Remove the screws, then pull out the trim. Remove the four screws holding the instrument panel in place. Pull the IP out slightly and disconnect the electrical connector. Locate the bulb socket and twist the retainer 1/4 turn and pull out. Replace bulb. Reverse the procedure to install.
# Remove the trunklid latch trim cover # Remove the electrical connector # Push in on the tabs and push light out of trunk