0
What else can I help you with?
When installing an IDE hard drive's configuration a master or slave is handled?
the hard drive should be set to master...
If you have an existing hard drive and want to install a second hard drive and you want to keep the first drive bootable as the bootable drive how should you configure the second hard drive?
If the Hard drive is IDE (40 pins on the back) you would configure the primary hard drive as Master and secondary hard drive as Slave using the jumpers on the back of the hard drive.
When installing a hard drive and a DVD writer on the same IDE channel which do you configure as the master and which as a slave?
Hard drive as master and DVD writer as slave.
When installing a hard drive and a CD-ROM drive on the same IDE channel which do you configure as the master and which as the slave?
Configure the hard drive as the master and the CD-ROM as the slave.
If a single hard disk is attached on a primary IDE channel what should the jumper be set to?
master if the ide cable has a single drive connection. if the ide cable has the master and slave connection. then set the drive to master with slave.
What should the primary jumper be set to On a primary IDE channel if a single hard disk is attached?
master if the ide cable has a single drive connection. if the ide cable has the master and slave connection. then set the drive to master with slave.
What determines if an IDE hard drive will act as a marter or slave im a particular configuration?
Arrangement of Jumper pins on Hard Drive
What is the difference between master IDE and slave IDE?
Each IDE slot can handle two drives. One drive will be the master and the other will be the slave depending o the configuration. If the jumpers of one drive is configured to set the drive as MA (Master), the second must be configured to SL (Slave). Both drives may be configured as CS (Cable Select), if so, The positioning on the ribbon cable will determine whic one is the master and which is the slave
When installing a hard drive and a CD-ROM drive on the same IDE channel which do you configure as the master and which as a slave?
The Harddrive needs to be set as "master" and the CD ROM as Slave.
When installing a second hard drive can you connect a EIDE into an IDE plug?
Yes.
How many hard drive can you connect on a motherboard with 4 sata and 1 ide controller?
To the IDE cable, 2 Hard disks can be connected as Master and Slave.(Hard disks that support IDE). 4 SATA ports could be used for 4 Hard Disks.
If a CD drive and a hard drive are sharing the same data cable in a computer system what type of connection is the CD drive using Which of the two drives should be set to master which to slave?
IF the CD drive shares an IDE channel with a hard drive, make the hard drive the master and the CD drive the slave.
