0
What else can I help you with?
What does a router do when it receives a data packet from another network segment?
nothing.
What network device can be used to segment a network to increase performance?
a) A router b) A switch c) All of the above
What device separates broadcast domains?
SwitchDescription: Network Switch a device that seperates the Broadcast domain of a LAN segment from other segments.
What do you call the router on a network that serves as an exit from that network?
stub router.
What is router bypassing?
Router is Bypassing to, system Network local Network and Internet or Network Regards NASEER
Can the bestbuy geeksquad help me with my wireless router setup?
You should verify that your router was purchased at a Best Buy. Before you call, make sure to have all the information about the router and your network connection available, and they should be able to help you.
What is a router on stick inter vlan routing?
A physical router device with an interface that routes between two or more VLANs that are attached to a VLAN network segment by a trunk link. In other words a " router on a [ TRUNK ] " which is originating from switches with independent non routing VLANs.
How do you configure RIP routing protocol on a Cisco router?
Here is a basic overview of the configuration of RIP on a Cisco router:Router(config)#router ripRouter(config-router)#network 192.168.1.0Router(config-router)#network 192.168.2.0Router(config-router)#network 192.168.3.0Router(config-router)#network 192.168.4.0Router(config-router)#network 192.168.5.0The 192.168.x.0 address can be changed to whatever address you would like to be broadcast over RIP. There are also other settings that can be configured.If you use RIPv2 you can also have the following configuration:Router(config)#router ripRouter(config-router)#version 2Router(config-router)#network 192.168.1.0Router(config-router)#network 192.168.2.0Router(config-router)#network 192.168.3.0Router(config-router)#network 192.168.4.0Router(config-router)#network 192.168.5.0Router(config-router)#exitRouter(config)#exitRouter#%SYS-5-CONFIG_I: Configured from console by consoleRouter#copy running-config startup-configDestination filename [startup-config]?Building configuration...[OK]Router#
How do network devices and transmit data?
Router
When a host on network A sends a message to a host on network B which address does the router look at?
When a host on network A sends a message to a host on network B, the router looks at the destination IP address in the packet’s header to determine where to forward the message. This IP address is used to identify the specific network and host within that network. The router uses its routing table to decide the best path for the packet based on this destination IP address. The MAC address is not used for routing between different networks, as it only applies to the local network segment.
When devices send packets to destinations not on their segment what actions must the router take?
The router must determine if it has a path to another network or router that may be in the path of the destination. When that occurs, it tries to find the "best path" (least cost) route to the destination. It has to consult its routing tables for that.
How does a router do?
the router filter & forward the data segment from one lan to another lan
