0
What else can I help you with?
What is a VW Jetta engine speed sensor?
The engine speed sensor provides the ECM with a crankshaft position signal. The ECM uses the signal to determine a crankshaft reference point (Top Dead Center) and calculate engine speed (RPM.) The signal is also used by the On-Board Diagnostic system for misfire detection. The ignition system will not operate if the ECM does not receive an engine speed sensor input.
Why would kinetic energy be used for long jumper?
Kinetic energy is important for long jumpers because it helps them generate the speed and power needed to take off from the board and propel themselves through the air. By converting their running speed into kinetic energy, long jumpers can maximize their jump distance. The greater the kinetic energy they can build up, the more potential energy they have to turn into distance during the jump.
What are any other three factors that determine the general perfomance of a computer system?
speed of ram, speed of cpu, how empty the hard disk drive is
Formula to determine speed and diameter?
The formula to determine speed is speed = distance / time. To determine the diameter of a circle, the formula is diameter = 2 x radius.
What is the maximum wind speed before you can't go skydiving?
15 knots for student jumpers, 20 knots for professionals
What is raddar?
Radar is an object-detection system that uses radio waves to determine the range, altitude, direction, or speed of objects
How do you make a speed bag board?
their is no such thing as a speed bag
What are jumpers and what are they use for in computers?
Jumpers are little caps that connect two pins from a header that is sticking up off of the circuit board. DIP switches often serve the same purpose. You would need a manual for whatever specific computer or motherboard to know the exact purpose of each jumper or switch.Since everything is more Plug and Play these days, jumpers and DIP switches are used much less on motherboards. When they were used, they were used to configure the processor speed, amount of memory, whether there was a math coprocessor inserted, what type of video card was used, and other configuration options. On peripheral cards, dip switches were used to determine what DMA channel, IRQ channel, and base address the device was allowed to use, as well as any options specific to the card. An older video card might have had a jumper to configure the amount of memory that was installed. On older hard drives, jumpers were used to select the parameters of the hard drive, whether it was in master (primary) or slave (secondary) configuration, any size translation options, etc. Newer hard drives might have jumpers to set the speed of the interface, or as a workaround for the alignment problem the newer drives can have.
If your traveling at 20 knots into 33knot winds how fast is your wind speed on board?
The wind speed on board will be the difference between the boat's speed and the wind speed, so 20 - 33 = -13 knots. This means that the wind speed on board will be 13 knots in the opposite direction of travel.
Formula for speed?
The formula to determine speed is Speed= wavelength*frequency
What determine the speed of the actuator?
Actuator speed is determined by:
How can one determine the wavenumber k in a given physical system?
In a physical system, the wavenumber k can be determined by dividing the angular frequency by the speed of the wave. The formula is k /v, where k is the wavenumber, is the angular frequency, and v is the speed of the wave.
