The power consumption of a MacBook Pro varies by model and usage, but generally, it draws between 2 to 4 amps when charging, depending on the specific model and its power adapter. For example, a 13-inch MacBook Pro typically uses a 61W adapter, while a 15-inch model uses an 87W adapter. Under heavy usage, the amp draw may increase, especially if the device is running intensive applications. Always refer to the specific power adapter specifications for exact figures.
30 amps
To calculate the amperage draw, you need to know the voltage of the circuit where the 2500 watts appliance will be used. You can use the formula: Amps = Watts / Volts. For example, if it is a 120V circuit, the amperage draw would be 2500 watts / 120 volts = 20.83 amps.
Parasitic draw on most vehicles should not exceed 50 milliamps (0.05 amps). A luxury vehicle with lots of accessories may draw as much as 80 milliamps (0.08 amps).
Watts = Amps x volts. What is the current draw and voltage of the calculator.
It's 75/120 and the answer is in amps.
Each electrical equipment draws a different amperage. Most residential dishwashers draw about six amps. There has to be a specification sticker on the inside of the door of the dishwasher ,which must such information stated on it. Commercial dishwashers could draw sixty amps and be using three phase power!!
To calculate the current, you can use the formula: current (in amps) = power (in watts) / voltage (in volts). So, for a 50W halogen lamp operating at 12V, the current draw would be approximately 4.17 amps (50W / 12V = 4.17A).
The wiring should allow for 115 amps.
A fuel injector's current draw, measured in amps, is a function of the fuel injector's actual impedance. Your answer is then necessarily dependent upon the impedance of your injectors. To determine your injector's draw, simply divide voltage by ohms. That is, given a 12v circuit and an injector with 12 ohms resistance, the draw is 1 amp (12 divided by 1).
The MacBook Pro cases are much larger and sturdier the the MacBook Air cases.
A 10 hp pump operating at 480 volts would draw approximately 15.6 amps of current. This can be calculated by dividing the power in watts by the voltage.
An Aquatop CP-25 circulated pump is rated at 30 amps. The pump will not typically draw this much current unless it is under fully load or is pulling a contaminated mixture.