Typically, for 10 lbs of grout, you would need to add approximately 1.4-1.6 gallons (5-6 liters) of water. It is important to check the specific instructions on the grout packaging as water requirements can vary.
550ml
Grout is little more than a mixture of sand and cement. To make grout, add just a little bit of sand to a bucket of cement. Mix it it a creamy paste. If you add too much sand, it will be too hard to stir.
Add 5 liters to the 7 liter bottle. Add 5 more to the 7 liter bottle; now you have 3 liters. Dump out the water from the 7 liter bottle. Then add the 3 liters to the 7 liter bottle. Fill the 5 liter bottle again and dump it into the 7 liter bottle. Dump out the water in the 7l bottle and add 1 liter to the 7 liter bottle. Add 5 liters to the 7 liter bottle and there you have it.
If you have directions telling you to add "5 parts water," it means that you add five times as much water as you add of something else that says to add "1 part." For example, if you add 1 part syrup and 5 parts water, you might add 100 ml of syrup and 500 ml of water, or you might add 1 liter of syrup and 5 liters of water, or you could add 3.627 liters of syrup and 18.135 liters of water, as long as the water is five times as much as the syrup.
You don't need to add any kind of grout to the eggshells. The grout, technically, is the painted background of the substrate or even unpainted before you add the eggshells.
To dilute a liquid to 50 percent, you would need to add an equal volume of water to the original liquid volume. For example, to dilute 1 liter of liquid to 50%, you would add 1 liter of water to make a total of 2 liters at 50% concentration.
1.569
In 1 Liter water add 500gm sugar
You add 9.09ml of stock solution to a volumetric and make it up to 1 litre to get a 110 dilution
After you have tiled, normally you will add the bonding liquid or sealant to the grout mixture. however there are liquids on the market that you can spray onto the tiles to seal the grout, however this is a temporary and not a recommended idea. It is better to scrap all the old grout out and re-grout with the proper mixture
Seawater has a salinity of arround 3.5 percent. 1 liter is 1000 cubic centimeters needs 35 gram of salt so get this solution.