shutdown -s -t 60
this is equivalent to 1 minute
go to start then type CMD then type shutdown -i then type in IP address of that persons computer then done
The code is: shell ("shutdown -s") That code should work for you.
It was shutdown because of scientology
there is really only one way to write in computer code it is by using the law of benjabenja.
Although not a virus, the command shutdown (Windows or *nix) will shutdown a computer.For Windows, the usage is shutdown [-i | -l | -s | -r | -a] [-f] [-m \\computername] [-t xx] [-c "comment"] [-d up:xx:yy] with the usage: -i Display GUI interface, must be the first option -l Log off (cannot be used with -m option) -s Shutdown the computer -r Shutdown and restart the computer -a Abort a system shutdown -m \\computername Remote computer to shutdown/restart/abort -t xx Set timeout for shutdown to xx seconds -c "comment" Shutdown comment (maximum of 127 characters) -f Forces running applications to close without warning -d [u] [p]:xx:yy The reason code for the shutdown u is the user code p is a planned shutdown code xx is the major reason code (positive integer less than 256) yy is the minor reason code (positive integer less than 65536)In *nix, the following applies:shutdown [-a][-t sec][-krhnfFc][time][warning-message] -a Use /etc/shutdown.allow. -t sec Tell init to wait sec seconds between sending processes the warning and the kill signal, before changing to another runlevel. -k Don't really shutdown; only send the warning messages to everybody. -r Reboot after shutdown. -h Halt after shutdown. -n Don't call init to do the shutdown but do it ourselves. The use of this option is discouraged, and its results are not always what you'd expect. -f Skip fsck on reboot. -F Force fsck on reboot. -c Cancel an already running shutdown. With this option it is of course not possible to give the time argument, but you can enter an explanatory message on the command line that will be sent to all users. time When to shutdown. warning-message Message to send to all users.
Any code that remotely controls another computer is far from simple. The simplest method would be to write a client-server application, where the client runs as a service awaiting a shutdown instruction from the server. However, it goes without saying that a network administrator would take a dim view of employees remotely shutting down other employee's computers.
Hacking or Reverse engineering is a method to understand the code of the certain network restriction which are implied while you are connected to the other computer and then by pass them using your own segments of code. You just reverse engineer the already existing security and encryption code. Learn more about encryption and Cryptography and then implementation of that in Security on internet.
The computer is indicating the presence of a fault code. Find out why the computer is doing that by using a code scanner.
code is TECHG1RL it's really but i already enter this code i sure you enter other code
binary transmission using a code based on Morse code
computer keyboards
You can't. You have to have an OBD2 tester/code analyzer.