To program your Uniden BC170 scanner, you will need to consult the user manual for specific frequencies and codes related to your area. Generally, you can enter frequencies manually using the keypad or program them using software like FreeScan. Make sure to check the local laws regarding scanner use, as some frequencies may be restricted. If you're looking for a specific code, please clarify the type of code you need (e.g., police, fire, etc.).
To unlock a Uniden 148XLT scanner, you typically need to enter a specific unlock code. This code can usually be found in the user manual or obtained from Uniden's customer support. Additionally, some scanners may have a physical lock switch that needs to be flipped to unlock the device. Ensure the scanner is powered on while performing these steps.
Firmware for the Uniden Bearcat scanner is typically downloaded directly to the scanner itself, not to your computer. You may need to use software on your computer to facilitate the transfer of the firmware to the scanner via a USB cable or similar connection. Always refer to the specific instructions provided by Uniden for your model to ensure proper updates.
An OBD1 type vehicle is not compatible with an OBD2 code scanner. You'll need to get the proper code scanner for your vehicle.
No, you need an OBD2 scanner in order to retrieve the code.
When you set up a Uniden Bearcat BC148XLT base scanner, you must program the frequencies you want to scan based on your area's frequencies. You do not need to include weather frequencies, because the BC148XLT includes weather frequencies pre-programmed in the base. You can add frequencies to your scanner in minutes, allowing you to customize the frequencies you scan.Press "Manual" to stop the scanning process. Press the number for the channel you want to program using the keypad on the scanner base. Press "Manual" after the channel number.Enter the frequency, including the decimals, using the buttons on the keypad.Press "E" to store the frequency.
You need to connect to a Comm port on a computer and use software found on the internet. It is fairly simple once you find a puter with the com port. I am not aware if a usb can be converted/used.
Visit the following address 20480 Chartwell Center Dr Suite F Cornelius, NC regarding the Bar code scanner
You have to fix the cause of the code that turned the light on. You will need a scanner to read the code.
You need a OBD2 scanner/code reader to get stored codes and to erase them
You need to connect to a Comm port on a computer and use software found on the internet. It is fairly simple once you find a puter with the com port. I am not aware if a usb can be converted/used.
You need OBD2 reader or scanner to get the codes
You have to hook up an OBD scanner to it. Most auto parts chains have one available, and can run a code diagnostic for free.