0
What else can I help you with?
What is the the loop back address in IPv6?
The loop back address for IPv6 is 0:0:0:0:0:0:0:1 or it is abbreviated as ::1
Where does the wizard obtain the loop-back address?
Your loop-back address or localhost is always 127.0.0.1. When a packet is sent to this address, the packet is routed internally to the network loopback device. The packet is then received back by your computer as if it came from an outside source.
What is the dotted decimal format of the loop back address?
127.0.0.1
What is the significance of the IP address 255.255.255.255?
global broadcasting domain
How do you a change a loop back ip address?
I don't think it is possible in DOS or windows, but you wouldn't want to change the localhost (loop back) address of 127.0.0.1 for it would cause a lot of problems with every part of your system.
The loop back address also known as local host is?
127.0.0.1 in IPv4 or ::1 in IPv6
What is an advantage of using a loop back interface on a router with OSPF enabled?
The main advantage of running a loop back interface with OSPF enabled on the router is that there is minimal cost. The IP address will also remain stable in this set up.
What is the reserved loopback IP address that can be used to test the configuration of the local IP device?
resever ip of loop back is 127.0.0.1
What is the difference between crocheting in the front loop versus the back loop of a stitch?
Crocheting in the front loop creates a raised ridge on the front of the fabric, while crocheting in the back loop creates a ribbed effect on the back of the fabric.
Do all men dress shirts have a loop on the back?
No, not all of them have that loop.
How do you start finger knitting?
You wrap the wool twice around your finger, then put the back loop over, then loop one more, back loop over, and so on.
What is the difference between finite open loop gain and closed loop gain?
In a closed loop system the gain without the feed back loop being closed is called open loop gain!!! e.g if forward gain is "A" and feed back factor is "B" then open loop gain is "AB" and closed loop gain will be [A/(A+B)]
