0
What else can I help you with?
The loop back address also known as local host is?
127.0.0.1 in IPv4 or ::1 in IPv6
What is the IPv6 equivalent of IPv4s loop back address of 127.0.0.1?
The IPv6 equivalent of the IPv4 loopback address 127.0.0.1 is ::1. This address is used to refer to the local host in IPv6, similar to how 127.0.0.1 functions in IPv4. The "::" notation represents a shorthand for consecutive blocks of zeros in IPv6 addressing.
Is a loop back address of127.100.100.10 a valid IP address?
loop back address can not be utilized.
What is the common DNS name for a loop back address?
The common DNS name for a loopback address is "localhost." It typically resolves to the IPv4 address 127.0.0.1 and the IPv6 address ::1. This name is used to refer to the local computer in networking contexts, allowing applications to communicate with themselves.
What can you use to identify a ipv6 address?
IPv6 address has 2^128 address and IPv6 address is of 16 bytes and is represented in colon hex notation.
How many bits are used for an IP address in IPv6?
IN IPv6 we can find 128bits.
How many bits are in an IPv6?
IPv6 uses a 128-bit address space
Where does the wizard obtain the loop-back address?
Your loop-back address or localhost is always 127.0.0.1. When a packet is sent to this address, the packet is routed internally to the network loopback device. The packet is then received back by your computer as if it came from an outside source.
Which address types are 128 bits in length?
IPv6 address
What is the dotted decimal format of the loop back address?
127.0.0.1
When a Cisco router is being moved from an IPv4 network to a complete IPv6 environment which series of commands would correctly enable IPv6 forwarding and interface addressing?
To enable IPv6 forwarding and configure interface addressing on a Cisco router moving to an IPv6 environment, you would first enter global configuration mode and enable IPv6 routing with the command ipv6 unicast-routing. Next, you would access the specific interface using interface <interface-name> and assign an IPv6 address with the command ipv6 address <ipv6-address>/<prefix-length>. Finally, use the command no shutdown to activate the interface.
Which address do you ping to verify tcp ipv6 protocols?
To verify TCP IPv6 protocols, you can ping the loopback address, which is ::1. This address is used to test the local network stack of the device itself. Additionally, you can ping a well-known IPv6 address, such as 2001:4860:4860::8888, which is a Google Public DNS server, to check connectivity over IPv6.
