No.
A PC would needs to have a power supply in order to take a 110 or 220v power input and convert it to the basic 12v power <and other rails> it uses.
Now most desktops can and do have the ability to handle 220v power. Consult your manual and make sure you have the little red switch on the back set to 220 unless your PSU is auto-switching. As always, check with your manual and manufacturer before assuming you can handle 220.
Hope that helps!
Direct supply is a term that is used usually during business agreements. It is a process where the producer deals with the primary customer without an involvement of a middleman.
You may connect it to any water supply pipe.
Yup called a diaphragm tank and NOT connected to the domestic supply
Direct Supply was created in 1985.
A "Berg" connector.
i have a question? in the earthing system should we connect the negative pole of supply to the earth for example a +24 power supply?
To connect a dishwasher to the water supply, you typically connect it to the hot water supply. This is because hot water helps to clean dishes more effectively than cold water.
In the heater you will have two wires. You should then have 2 supply wires from the panel, and 2 wires from the thermostat. The neutral (white) supply wire should go to one of the wires on the heater. The hot (black) supply wire should connect to one wire from the thermostat. The other wire from the thermostat will connect to the other wire from the heater.
You should connect your dishwasher to the hot water supply for optimal performance and efficiency. This helps the dishwasher clean dishes better and use less energy during the washing cycle.
Yes, you can connect a 3-wire fan to a 2-wire supply, but you will lose the functionality of one of the wires. Typically, the third wire on a fan is used for speed control or monitoring purposes. If you connect a 3-wire fan to a 2-wire supply, the fan will run at full speed without the ability to adjust it.
To connect a faucet to a water supply line using an adapter, first, ensure the water supply is turned off. Then, attach the adapter to the water supply line and connect the faucet to the adapter using the appropriate fittings. Finally, turn on the water supply and check for any leaks.
To name a few: Above Board Electronics, Action Industrial Supply and Bergen Industrial Supply have partner connect.