answersLogoWhite

0

The Urei 1176LN compressor features an input impedance of approximately 600 ohms, which is typical for professional audio equipment. The output impedance is around 200 ohms. These impedances ensure proper matching with various audio sources and destinations, facilitating optimal signal transfer and maintaining audio quality.

User Avatar

AnswerBot

6mo ago

What else can I help you with?

Related Questions

Can you improve voltage level in the range of millivolt into a 15volt?

A voltage amplifier (high input and output impedances) with a gain of 83.5 dB will amplify a signal of 1 millivolt to an output of 15 volts.


How can you save audio on your laptop from your email document?

Connect a cable from your speaker output to your microphone input. Use a sound recording program like Audacity (available online for free) to record the sound as it plays. Since the input and output impedances are different, you have to keep the output volume extremely low otherwise it will be very distorted.


What is the self-sustaining speed of gas turbine?

self sustaining speed is output of a turbine= input into compressor


How do you get input impedance and output impedance?

Look at "Different names for the two impedances Z1 and Z2": Scroll down to related links and look at "Calculation the damping of impedance bridging or power matching an interface connecting Zout and Zin". Scroll down to related links and look at "Measurement of input impedance and output impedance".


Is an OMR an input or output?

is an omr and input or output device?


Is interactive whiteboard an input or output device?

both input r output


Is a graphic tablet output or input?

Input device.


How do you calculate efficiency of air compressor?

One measure of efficiency is power output/power input. Assuming that you have in the input power to the compressor in watts, the output flow rate in liters per minute, and the output pressure in bar(absolute), then the formula for efficiency is (V * 100 * ln (P))/Input Where v is flow rate in liters per second referenced to atmospheric pressure, P is pressure in bar, and Input is power to the compressor in watts. This also assumes that the input air is roughly atmospheric pressure and near room temperature, and the output air has cooled back to near room temperature. A rule of thumb is that 1 hp into a compressor will generate 4cfm at 100psi. Lets see what efficiency that is. 1 cfm = 1cu ft * 28.3 liter/cu ft * 1 minute/60 second = 0.472 liters per sec 100psig = 115psia = 7.9 bar absolute 4 cfm = 4*0.472 lps = 1.89 lps 1.89 * 100 * log-natural (7.9) = 390 watts of output power 1 horsepower = 746 watts. 390/746 = 52% efficiency


How do you calculate efficiency of refrigerator compressor?

During colder months, it's typical that frost, and sometimes ice, builds up on the outdoor cabinet housing a heat pump's condenser coil, compressor and fan. Normally, the heat pump's defrost cycle melts the accumulated frost or ice, but severe ice buildup may indicate a problem with the unit


Is a projector input or output?

it is an output device


What is the input to output ratio formula?

output/input


Is Digitizing Pad is an input or an output?

output and input