cablez
The device allowing two computers to communicate with each other is... a router (or modem).
Although VLANs and subnets are quite different concepts, when using VLANs, there should be a one-to-one correspondence between the two. That is, every VLAN should be in a different subnet.Although VLANs and subnets are quite different concepts, when using VLANs, there should be a one-to-one correspondence between the two. That is, every VLAN should be in a different subnet.Although VLANs and subnets are quite different concepts, when using VLANs, there should be a one-to-one correspondence between the two. That is, every VLAN should be in a different subnet.Although VLANs and subnets are quite different concepts, when using VLANs, there should be a one-to-one correspondence between the two. That is, every VLAN should be in a different subnet.
A physical router device with an interface that routes between two or more VLANs that are attached to a VLAN network segment by a trunk link. In other words a " router on a [ TRUNK ] " which is originating from switches with independent non routing VLANs.
To enable communication between hosts on VLAN 10 and VLAN 20, a router or Layer 3 switch is required to perform inter-VLAN routing. This device must have interfaces configured for both VLANs, either through sub-interfaces or routed ports. Additionally, proper routing protocols or static routes should be configured to facilitate traffic between the two VLANs. Finally, the necessary access control lists (ACLs) should be set up to allow the desired traffic between the VLANs.
The network virtualization technique that enables two virtual LANs (VLANs) at different sites to connect over a WAN is known as Virtual Private LAN Service (VPLS). VPLS uses MPLS (Multiprotocol Label Switching) to create a virtualized Ethernet network, allowing geographically dispersed VLANs to function as if they were on the same local network. This technique provides seamless connectivity and allows for efficient communication between the VLANs across the WAN.
A traveler wire is a wire used in a three-way electrical circuit to connect two switches that control the same light or electrical device. It allows the switches to communicate and control the flow of electricity to the device.
An autodialler is an electronic device which can automatically dial telephone numbers to communicate between two points in a network.
A router
The same way you walk on clouds.
Instant Messenger is a program that allows two users to communicate simultaneously. You can download a program that allows you to do this on your computer.
VLAN is a group of hosts with a common set of requirements that communicate as if they were attached to the same broadcast domain, regardless of their physical location. Inter VLAN is defined as two VLANS connected to each other and communicating.
An autodialler is an electronic device which can automatically dial telephone numbers to communicate between two points in a network.