push rods
location on the motherboard into which a controller card for a peripheral device is stored
You need to download the files from the digital camera by either connecting the device or inserting the SD Card into the slot, if your computer supports the last option. Then, copy the files onto a blank CD or DVD.
The purpose of the CF slot in this device is to allow for the insertion of a CompactFlash memory card, which can be used to store and transfer data such as photos, videos, and other files.
The ram slot is on the system board.It can be located beside the integrated device electronics connectors(that is the I.D.E connectors).
Yes, the larger slot is a polarity slot that is supposed to connect the plug in device to the neutral wire. If the device is a lamp it would make the shell of the lamp the neutral wire connection and the center pin the "hot". If the two wire plug has a moulded plug on it, look for a tracer on the devices power cord. It will be a raised rib or a white tracer on the conductor that is the neutral. Position the two blade plug into the receptacle with the identified conductor into the larger slot, this will give you the proper polarity configuration that the manufacturer recommends. New plugs (caps) today all have a ground pin connected to them and can only connect to the receptacle in one position.
The larger of the two is neutral, smaller is hot.
Insert the target device into a USB slot, and open it. Open the location where your picture is stored. Drag-and-drop the picture to the USB device. Remove the device from the USB slot. The picture has been copied, and you're all done.
Inserting a DVD into the Mac's DVD drive slot will usually launch the DVD Player software. No uploading is required.
It allows for a separate equipment grounding conductor
This Slot is use to insert small sized Memory Chips(SSD- Solid State Device), Which are firstly inserted into an adapter then ti inserted into Adapter Slot.
IRQ
floppy disc